EZ-400-NM-75 Datasheet, PDF (2/2 Pages) Pasternack Enterprises, Inc. – Connecter

TIMES ^{MICROWAVE SYSTEMS}
EZ-400-NM-75 (stock code: 3190-1618)
Type N PLUG
Non-solder center contact
Crimp-on (.429" hex. die) outer contact
INSTALLATION INSTRUCTIONS
(Cable Types: LMR-400-75)
SLIGHT CHAMFER
3/16” (.180)
9/32”
( 280)
5/8”(.590)
STEP 1
1. (A) Trim cable to dimensions shown.
(B) Remove any residual plastic from center
conductor.
(C) Deburr center conductor using a fine file or Times
DBT-01 tool.
(D) Avoid nicking aluminum tape.
WEATHER SEAL
2. (A) Slide weather seal and crimp ferrule over cable.
CRIMP FERRULE _{(B) Flare braid and insert cable into connector body}
until dielectric is seated with all braid wires on
outside of connector body and aluminum tape
inside connector body.
(C) Braid should assemble flush to within 1/16” (.06)
TRIM BRAID
of
STEP 2
connector shoulder. Trim excess if necessary.
STEP 3
3. (A) Slide crimp ferrule over braid and crimp as
close to
body as possible using hex. die indicated in a
Times
HX-4 crimp tool or equivalent. Do not crimp rear
of
crimp ferrule.