PE85N1005 Datasheet, PDF (1/5 Pages) Pasternack Enterprises, Inc. – SMA Calibrated Noise Source Module, Output ENR of 23 dB, +28 VDC, 1 GHz to 18 GHz

SMA Calibrated Noise Source Module, Output
ENR of 23 dB, +28 VDC, 1 GHz to 18 GHz
Noise Generators Technical Data Sheet
PE85N1005
Features
• 1 GHz to 18 GHz Bandwidth
• Calibrated Frequencies: 1 GHz steps
• High ENR output: 23 dB min
• Typical Flatness +/- 2.0 dB
• Excellent Stability
• Noise Output Temperature Variation: <0.01 dB/°C
• Noise Output Variation <0.1 dB/%V
• Rugged Package Design supports output Female SMA
connector
• Designed to meet MIL-STD-202F environmental test
conditions
Applications
• Noise Figure Measurements
• Built-In Test equipment for signal
strenth calibrators and radar
applications
• Automatic Test Equipment (ATE)
.
• Jamming
• Baseband Signal Simulation
• Additive White Gausian Noise
(AWGN) source for Error Rate
Measurements
• Increase dynamic range of A/D
Converters
• SATCOM for bit error rate (BER)
and noise figure
• Can be used as a Jitter source.
Description
The PE85N1005 is a coaxial packaged Noise Source module which operates over a wide frequency range from 1 GHz to
18 GHz. The design is calibrated in 1 GHz steps and is ideal for Noise Figure measurements and a variety of built-in test
applications. This model operates at +28 Vdc and features a high output ENR level of 23 dB min, typical flatness across
the entire frequency band is +/- 2.0 dB, and excellent stability. Performance is specified over -55°C to +85°C with Noise
Output Temperature Variation <0.01 dB/°C, Noise Output Variation <0.1 dB/%V. The rugged package design supports an
output Female SMA connector with an EMI/RFI filter voltage pin and ground tab. Additionally, the model is designed to meet
a variety of demanding MIL-STD-202F environmental test conditions including Humidity, Thermal Shock, and Vibration for
added confidence for highly reliable operation.
Electrical Specifications
RF Characteristics
Description
Minimum
Typical
Maximum
Units
Frequency Range
1
18
GHz
Impedance 50 Ohms
Output ENR
23
dB
Flatness ±2 dB
VSWR 3:1
Output Variation vs Input Voltage
0.1
dB/%V
Output Variation vs Temperature
0.01
dB/deg C
Bias Voltage 1
28
Volts
Input Current 1
25
mA
Calibration Points
.
1 GHz Steps
Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: SMA Calibrated Noise Source Module, Output ENR of 23 dB, +28 VDC, 1 GHz to 18 GHz
PE85N1005
PE85N1005 REV 1.1
1