PE85N1000 Datasheet, PDF (1/6 Pages) Pasternack Enterprises, Inc. – SMA Calibrated Noise Source Module, Output ENR of 15 dB, +28 VDC, 0.01 MHz to 2 GHz

SMA Calibrated Noise Source Module, Output ENR
of 15 dB, +28 VDC, 0.01 MHz to 2 GHz
Noise Generators Technical Data Sheet
PE85N1000
Features
• 10 KHz to 2000 MHz Bandwidth
• Calibrated Frequencies: 10
• 100
• 1000
• 2000 MHz
• ENR output: 15 dB min
• Typical Flatness +/- 1.5 dB
Applications
• Noise Figure Measurements
• Built-In Test equipment for signal
strenth calibrators and radar
applications
• Automatic Test Equipment (ATE)
.
• Excellent Stability
• Noise Output Temperature Variation: <0.01 dB/°C
• Noise Output Variation <0.1 dB/%V
• Rugged Package Design supports output Female SMA
connector
• Designed to meet MIL-STD-202F environmental test
conditions
• Jamming
• Baseband Signal Simulation
• Additive White Gausian Noise
(AWGN) source for Error Rate
Measurements
• Increase dynamic range of A/D
Converters
• SATCOM for bit error rate (BER)
and noise figure
• Can be used as a Jitter source.
Description
The PE85N1000 is a coaxial packaged Noise Source module which operates over a wide frequency range from 10 KHz to 2
GHz. The design is calibrated for 10, 100, 1000, and 2000 MHz frequencies and is ideal for Noise Figure measurements and
a variety of built-in test applications. This model operates at +28 Vdc and features an ENR level of 15 dB min, typical flatness
across the entire frequency band is +/- 0.5 dB, and excellent stability. Performance is specified over -55°C to +85°C with
Noise Output Temperature Variation <0.01 dB/°C, Noise Output Variation <0.1 dB/%V. The rugged package design supports
an output Female SMA connector with an EMI/RFI filter voltage pin and ground tab. Additionally, the model is designed to
meet a variety of demanding MIL-STD-202F environmental test conditions including Humidity, Thermal Shock, and Vibration
for added confidence for highly reliable operation.
Electrical Specifications
RF Characteristics
Description
Minimum
Typical
Maximum
Units
Frequency Range
10KHz
2
GHz
Impedance 50 Ohms
Output ENR
15
dB
Flatness ±1.5 dB
VSWR 1.25:1
Output Variation vs Input Voltage
0.1
dB/%V
Output Variation vs Temperature
0.01
dB/deg C
Bias Voltage 1
28
Volts
Input Current 1
20
mA
Calibration Points
.
10, 100, 1000, and 2000 MHz
Click the following link (or enter part number in “SEARCH” on website) to obtain additional part information including price,
inventory and certifications: SMA Calibrated Noise Source Module, Output ENR of 15 dB, +28 VDC, 0.01 MHz to 2 GHz
PE85N1000
PE85N1000 REV 1.1
1