A-551E Datasheet, PDF (6/11 Pages) PARA LIGHT ELECTRONICS CO., LTD. – 0.56 INCH SINGLE DIGIT DISPLAY

Release by
PARALIGHTDCC
0.56 INCH SINGLE DIGIT DISPLAY
—SOLDERING
A-551E
REV:A / 2
METHOD
SOLDERING CONDITIONS
REMARK
— Solder no closer than 2mm
DIP
SOLDERING
Bath temperature: 260max
Immersion time: with 5 sec
from the base of the package
— Using soldering flux,” RESIN FLUX”
is recommended.
— During soldering, take care not to
Soldering iron: 30W or smaller
press the tip of iron against the
SOLDERING _{Temperature at tip of iron: 260℃ or lower PIN.}
IRON
Soldering time: within 5 sec.
(To prevent heat from being
transferred directly to the PIN.)
1) When soldering the PIN of Display in a jig that the package is fixed with a panel (See fIg.1), be
careful not to stress the PIN with iron tip. When soldering Display in a condition that the package is
fixed with a panel, be careful not to cling and stress the surface of Display on the panel to avoid
damaging the Display.
Fig.1
DRAWING NO. : DS-11-03-0138
DATE : 2010-12-21
Page : 6