|
A-1001G-A Datasheet, PDF (6/10 Pages) PARA LIGHT ELECTRONICS CO., LTD. – 1.00 INCH SINGLE DIGIT DISPLAY | |||
|
◁ |
Release by
PARALIGHTDCC
1.00 INCH SINGLE DIGIT DISPLAY
A-1001G-A G/W
REV:A / 0
2) Similarly, when a jig is used to solder the Display to PC board, take care as much as possible to
avoid steering the PIN (See Fig.2).
Fig.2
3) Repositioning after soldering should be avoided as much as possible. If inevitable, be sure to
preserve the soldering conditions with irons stated above: select a best-suited method that
assures the least stress to the Display.
4) PIN cutting after soldering should be performed only after the Display temperature has returned
to normal temperature.
âLED MOUNTING METHOD
1) When mounting the Display by using a case, as shown Fig.3, ensure that the mounting holds on
the PC board match the pitch of the PIN correctly-tolerance of dimensions of the respective
components including the Display should be taken into account especially when designing the
case, PC board, etc. to prevent pitch misalignment between the PIN and board holes, the
diameter of the board holes should be slightly larger than the size of the PIN. Alternatively, the
shape of the holes should be made oval. (See Fig.3)
DRAWING NO. : DS-11-11-0081G
Fig.3
DATE : 2011-02-22
Page :6
|
▷ |