L-T690WDT-NWA Datasheet, PDF (14/14 Pages) PARA LIGHT ELECTRONICS CO., LTD. – SURFACE MOUNT DEVICE LED

Release by
PARA LIGHT DCC
SURFACE MOUNT DEVICE LED
Part No. : L-T690WDT-NWA
REV: A / 2
2、Test Items And Results
Test Item
Reference
Standard
Resistance to Soldering Heat
JEITA
(Reflow Soldering)
ED-4701300 301
Solder ability (Reflow Soldering)
JEITA
ED-4701300 303
Test Condition
Tsld=260℃,10sec.
(Pre treatment
30℃,70%,168hrs)
Tsld=215℃,3sec.
(Lead Solder)
Number
Note
of
Damaged
2times 0/50
1time
over 95%
0/50
Thermal Shock
JEITA
ED-4701300 307
-40℃ ~ 100℃
30min. 30min.
100cycles 0/50
Temperature Cycle
High Temperature Storage
JEITA
ED-4701100 105
-40℃ ~ 25℃~100℃~25℃
30min. 5min. 30min. 5min
100cycles
0/50
JEITA
ED-4701200-
201
Ta=100℃
1000hrs. 0/50
Temperature Humidity Storage
JEITA
ED-4701100 103
Ta=60℃,RH=90%
1000hrs. ^0/50
Low Temperature Storage
JEITA
ED-4701200 202
Ta=-40℃
1000hrs. _0/50
Steady State Operating Life
Condition
Ta=25℃,IF=60mA
1000hrs. _0/50
Steady State Operating Life
of High Humidity Heat
Ta=60℃,RH=90%,IF=60mA ^500hrs. 0/50
7. Cleaning
Û If cleaning is required , use the following solutions for less than 1 minute and less than 40℃.
Û Appropriate chemicals: isopropyl alcohol. (When using other solvents, it should be confirmed
beforehand whether the solvents will dissolve the package and the resin or not.)
Û Effect of ultrasonic cleaning on the LED resin body differs depending on such factors as
ultrasonic power and the assembled condition. Before cleaning, a pre-test should be
confirm whether any damage to the LEDS will occur.
8.Others:
The appearance and specifications of the product may be modified for improvement without notice.
DRAWING NO. : DS-31P-12-0002
PARA-FOR-068
DATE : 2012-5-8 PAGE
14 of 14