L-C191JGCT Datasheet, PDF (11/14 Pages) PARA LIGHT ELECTRONICS CO., LTD. – SURFACE MOUNT DEVICE LED

SURFACE MOUNT DEVICE LED
Part No. : L-C191JGCT
REV:A / 4
z CAUTIONS
1.Application Limitation :
The LED’s described here are intended to be used for ordinary electronic equipment (such as office equipment,
communication equipment and household application).Consult PARA’s sales in advance for information on
application in which exceptional quality and reliability are required, particularly when the failure or malfunction of
the LED’s may directly jeopardize life or health (such as airplanes, automobiles, traffic control equipment, life
support system and safety devices).
2.Storage :
Before opening the package :
The LEDs should be store kept at 5°C to 30°C or less and 85%RH or less.
After opening the package :
The LEDs should be kept at 5°C to 30°C or less and 70%RH or less. The LEDs should be soldered within 168
hours(7 days) after opening the package.
Please avoid rapid transitions in ambient temperature in high humidity environments where condensation may occur.
LEDs stored out of their original packaging for more than a week should be baked at 30°C for at 24 hours before
solder assembly.
3.Soldering
Do not apply any stress to the lead frame during soldering while the LED is at high temperature.
Recommended soldering condition.
Reflow Soldering :
Pre-heat 120~150°C, 120sec. MAX., Peak temperature : 240°C Max. Soldering time : 10 sec Max.
Soldering Iron : (Not recommended)
DRAWING NO. : DS-74-07-0020
PARA-FOR-068
DATE : 2011-01-06 PAGE 11 of 14