PG600A Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – GLASS PASSIVATED JUNCTION PLASTIC RECTIFIER(VOLTAGE - 50 to 800 Volts CURRENT - 6.0 Amperes)

PG600A THRU PG600K
GLASS PASSIVATED JUNCTION PLASTIC RECTIFIER
VOLTAGE - 50 to 800 Volts CURRENT - 6.0 Amperes
FEATURES
l High surge current capability
l Plastic package has Underwriters Laboratory
Flammability Classification 94V-O Utilizing
Flame Retardant Epoxy Molding Compound
l Glass passivated junction in P600 package
l High current operation 6.0 Amperes @ T_A=75 ¢J
l Exceeds environmental standards of MIL-S-19500/228
P600
MECHANICAL DATA
Case: Molded plastic, P600
Terminals: axial leads, solderable per MIL-STD-202,
Method 208
Polarity: Color band denotes cathode
Mounting Position: Any
Weight: 0.07 ounce, 2.1 gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
*@ T_A=25 ¢J unless otherwise specified. Single phase, half-wave,60 Hz, resistive or inductive load.
**All values except Maximum RMS Voltage are registered JEDEC parameters.
PG600A PG600B PG600D PG600G PG600J PG600K UNITS
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
50
100 200 400 600 800
V
35
70
140 280 420 560
V
Maximum DC Blocking Voltage
50
100 200 400 600 800
V
Maximum Average Forward
6.0
A
Rectified Current at T_A=75 ¢J
A
Maximum Overload Surge Current at 1 cycle (NOTE 1)
300
A
Maximum Forward Voltage at 6.0 ADC
Maximum Full Load Reverse Current Full Cycle
Average at 25 ¢J
1.0
V
10
£g ADC
Maximum DC Reverse Current at Rated
DC Blocking Voltage and 100 ¢J
0.3
m^ADC
Typical Junction capacitance (Note 2) CJ
Typical Thermal Resistance (Note 3) R £KJA
Typical Thermal Resistance (Note 3) R £KJL
150.0
20.0
4.0
P^F
¢J /W
¢J /W
Operating Temperature Range
-55 to +150
¢J
Storage Temperature Range
-55 to +150
¢J
NOTES:
1. Peak forward surge current, per 8.3ms single half-sine-wave superimposed on rated load(JECED method)
2. Measured at 1 MHZ and applied reverse voltage of 4.0 volts
3. Thermal resistance from junction to ambient and from junction to lead at 0.375"(9.5mm) lead length P.C.B.
mounted with 1.1×1.1(30×30mm) copper pads