P6SMBJ_07 Datasheet, PDF (1/5 Pages) Pan Jit International Inc. – SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR

P6SMBJ SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR
VOLTAGE 5.0 to 220 Volts PEAK PULSE POWER 600 Watts
Recongnized File # E210467
SMB/DO-214AA
Unit: inch (mm)
FEATURES
• For surface mounted applications in order to optimize board space.
• Low profile package
• Built-in strain relief
• Glass passivated junction
• Low inductance
• Typical I_D less than 1.0µA above 10V
• Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
• High temperature soldering : 260°C /10 seconds at terminals
• In compliance with EU RoHS 2002/95/EC directives
MECHANICAL DATA
• Case: JEDEC DO-214AA,Molded plastic over passivated junction.
• Terminals: Solder plated,solderable per MIL-STD-750,Method 2026
• Polarity: Color band denotes positive end (cathode)
• Standard Packaging:12mm tape (EIA-481)
• Weight: 0.003 ounce, 0.093 gram
.185(4.70)
.160(4.06)
.012(.305)
.006(.152)
.050(1.27)
.030(0.76)
.008(.203)
.002(.051)
.220(5.59)
.200(5.08)
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types P6SMBJ5.0 thru types P6SMBJ220.
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
Rating
Peak Pulse Power Dissipation on 10/1000uS waveform (Notes 1,2, Fig.1)
Peak Forward Surge Current 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method) (Notes 2,3)
Peak Pulse Current on 10/1000us waveform(Note 1)Fig.3
Operating Junction and Storage Temperature Range
Symbol
P_PPM
I_FSM
I_PPM
T ,T
J STG
Value
600
100
see Table 1
-55 to +150
Units
Watts
Amps
Amps
O_C
NOTES:
1. Non-repetitive current pulse, per Fig.3 and derated above TA = 25 ^OC per Fig. 2.
2. Mounted on 5.0mm² (0.13mm thick) land areas.
3. Measured on 8.3ms, single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum.
STAD-MAY.25.2007
PAGE . 1