KBU6A Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – SILICON SINGLE-PHASE BRIDGE RECTIFIER(VOLTAGE - 50 to 800 Volts CURRENT - 6.0 Amperes)

KBU6A~KBU6K
DATA SHEET
SILICON SINGLE-PHASE BRIDGE RECTIFIER
VOLTAGE - 50 to 800 Volts CURRENT - 6.0 Amperes
Recongnized File # E111753
FEATURES
• Plastic material has Underwriters Laboratory
Flammability Classification 94V-O
• Ideal for printed circuit board
• Reliable low cost construction utilizing molded plastic technique
• Surge overload rating: 175 Amperes peak
• High temperature soldering guaranteed:
260°C/10 seconds/.375"(9.5mm) lead length at 5 lbs. (2.3kg) tension
MECHANICAL DATA
Case: Reliable low cost construction utilizing
molded plastic technique
Terminals: Leads solderable per MIL-STD-202,
Method 208
Mounting position: Any
Mounting torque: 5 in. lb. Max.
Weight: 0.3 ounce, 8.0 grams
KBU
.933(23.7)
.894(22.7)
~~
R .075(1.9) (2x)
.052(1.3)
.047(1.2)
.220(5.6)
.181(4.6)
Unit: inch ( mm )
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
KBU6A KBU6B KBU6D KBU6G KBU6J
Maximum Recurrent Peak Reverse Voltage
50
100
200
400
600
Maximum RMS Input Voltage
35
70
140
280
420
Maximum DC Blocking Voltage
50
100
200
400
600
Maximum Average Forward T_C=100°C
6.0
Rectified Output Current atTA=40°C
6.0
I²t Rating for fusing ( t<8.3ms)
127
Peak Forward Surge Current single sine-wave superimposed on rated load
(JEDEC method)
175
Maximum Instantaneous Forward Voltage Drop per element at 6.0A
1.0
Maximum Reverse Leakage at rated T_A=25°
CDc Blocking Voltage per element T_C=100°C
10
1000
Typical Thermal Resistance per leg(Note 2) RθJA
8.6
Typical Thermal Resistance per leg(Note 3) RθJC
3.1
Operating and Storage Temperature Range, TJ,TSTG
-55 to +150
KBU6K
800
560
800
UNIT
V
V
V
A
A²sec
Apk
Vpk
µA
µA
°C / W
°C / W
°C
NOTES:
1. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw.
2. Units Mounted in free air, no heatsink, P.C.B at 0.375"(9.5mm) lead length with 0.5 x 0.5"(12 x 12mm)copper pads.
3. Units Mounted on a 2.0 x 1.6" x 0.3" thick (5 x 4 x 0.8cm) AL plate.
PAGE . 1