GS1A_07 Datasheet, PDF (1/3 Pages) Pan Jit International Inc. – SURFACE MOUNT RECTIFIER

GS1A~GS1M
SURFACE MOUNT RECTIFIER
VOLTAGE 50 to 1000 Volts CURRENT 1.0 Amperes
FEATURES
• For surface mounted applications
• Low profile package
• Built-in strain relief
• Easy pick and place
• Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
• Low Forward Drop
• High temperature soldering : 260°C /10 seconds at terminals
• Glass Passivated Chip Junction
• In compliance with EU RoHS 2002/95/EC directives
MECHANICAL DATA
• Case: JEDEC DO-214AC molded plastic
• Terminals: Solder plated, solderable per MIL-STD-750,Method 2026
• Polarity: Indicated by cathode band
• Standard packaging: 12mm tape (EIA-481)
• Weight: 0.002 ounce, 0.064 gram
SMA/DO-214AC
Unit: inch (mm)
.181(4.60)
.157(4.00)
.012(.305)
.006(.152)
.060(1.52)
.030(0.76)
.008(.203)
.002(.051)
.208(5.28)
.188(4.80)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25°C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
PA RA ME TE R
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
Maximum DC Blocking Voltage
Maximum Average Forward Current .375"(9.5mm)
lead length at T_L=100 ^OC
Peak Forward Surge Current : 8.3ms single half sine-wave
superimposed on rated load(JEDEC method)
Maximum Forward Voltage at 1.0A
Maximum DC Reverse Current at T =25OC
J
Rated DC Blocking Voltage T_J=125^OC
Typ i c a l J unc ti o n c a p a c i ta nc e (No te 1 )
Typ i c a l J unc ti o n Re s i s ta nc e (No te 2 )
Op e ra ti ng a nd S to ra g e Te m p e ra ture Ra ng e
S YMB OL GS 1 A GS 1 B GS 1 D GS 1 G GS 1 J GS 1 K GS 1 M UNITS
V _RRM
50 100 200 400 600 800 1000
V
V _RMS
35
70 140 280 420 560 700
V
V _DC
50 100 200 400 600 800 1000
V
I_{F ( AV )}
1.0
A
I_{F S M}
30
A
V_F
1.1
V
I_R
5.0
50
uA
C_J
R _{θJ L}
T_J,T_STG
12
30
-55 TO +150
pF
O_{C / W}
O_C
NOTES:1. Measured at 1 MHz and applied V_r = 4.0 volts.
2. 8.0 mm² ( .013mm thick ) land areas.
STAD-FEB.23.2007
PAGE . 1