GBU4A Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER(VOLTAGE 50 to 800 Volts CURRENT - 4.0 Amperes)

DATA SHEET
GBU4A~GBU4K
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
VOLTAGE 50 to 800 Volts CURRENT - 4.0 Amperes
GBU
FEATURES
• Plastic material has Underwriters Laboratory
Flammability Classification 94V-O
• Ideal for printed circuit board
• Reliable low cost construction utilizing molded plastic technique
• Surge overload rating: 150 Amperes peak
• High temperature soldering guaranteed:
260°C/10 seconds/.375"(9.5mm) lead length at 5 lbs. (2.3kg) tension
.880(22.3)
.860(21.8)
.160(4.1)
.140(3.5)
MECHANICAL DATA
Case: Reliable low cost construction utilizing
molded plastic technique
Terminals: Leads solderable per MIL-STD-202,
Method 208
Mounting position: Any
Mounting torque: 5 in. lb. Max.
Weight: 0.15 ounce, 4.0 grams
.100(2.54)
.085(2.16)
.080(2.03)
.065(1.65)
.190(4.83)
.210(5.33)
.050(1.27)
.040(1.02)
Unit: inch ( mm )
.140(3.56)
.130(3.30)
.040(1.02)
.030(0.76)
.022(0.56)
.018(0.46)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
GBU4A GBU4B GBU4D
GBU4G GBU4J
Maximum Recurrent Peak Reverse Voltage
50
100
200
400
600
Maximum RMS Input Voltage
35
70
140
280
420
Maximum DC Blocking Voltage
50
100
200
400
600
Maximum Average Forward T_C=100°C
4.0
Rectified Output Current atTA=40°C
3.0
I2t Rating for fusing ( t<8.3ms)
93
Peak Forward Surge Current single sine-wave superimposed on
150
rated load(JEDEC method)
Maximum Instantaneous Forward Voltage Drop per element at 2.0A
1.0
Maximum Reverse Leakage at rated TA=25°
5
CDc Blocking Voltage per element T_C=100°C
500
Typical Thermal Resistance per leg(Note 2) RθJA
19
Typical Thermal Resistance per leg(Note 3) RθJA
4
Operating and Storage Temperature Range, T_J,TSTG
-55+150
GBU4K
800
560
800
UNIT
V
V
V
A
A²sec
Apk
Vpk
µA
µA
°C / W
°C / W
°C
NOTES:
1. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw.
2. Units Mounted in free air, no heatsink, P.C.B at 0.375"(9.5mm) lead length with 0.5 x 0.5"(12 x 12mm)copper pads.
3. Units Mounted on a 2.0 x 1.6" x 0.3" thick (5 x 4 x 0.8cm) AL plate.
DATE : SEP.12.2002
PAGE . 1