CP800 Datasheet, PDF (1/2 Pages) Pan Jit International Inc. – SINGLE-PHASE SILICON BRIDGE(VOLTAGE - 50 to 800 Volts CURRENT - P.C. MTG 3A, HEAT-SINK MTG 8A)

CP800 THRU CP808
SINGLE-PHASE SILICON BRIDGE
VOLTAGE - 50 to 800 Volts CURRENT - P.C. MTG 3A, HEAT-SINK MTG 8A
Recongnized File #E111753
CP-8
FEATURES
l Surge overload rating—200 Amperes peak
l Low forward voltage drop and reverse leakage
l Small size, simple installation
l Plastic package has Underwriter Laboratory
Flammability Classification 94V-O
l Reliable low cost construction utilizing molded
plastic technique
MECHANICAL DATA
Mounting position: Any
Weight: 0.24 ounce, 6.9 grams
Terminals: Leads solderable per MIL-STD-202,
Method 208
Mounting torque: Thro hole for #6 screw
MACXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
At 25 ¢J ambient temperature unless otherwise noted; resistive or inductive load at 60Hz .
CP800 CP801 CP802 CP804 CP806
Max Recurrent Peak Reverse Voltage
50
100
200
400
600
Max Bridge Input Voltage RMS
35
Max Average Rectified Output at T_C=50 ¢J *
See Fig. 2
at T_A=40 ¢J **
70
140
280
420
8.0
3.0
Peak One Cycle Surge Overload Current
200
Max Forward Voltage Drop per element at
1.1
4.0A DC & 25 ¢J . See Fig. 3
Max Rev Leakage at rated Dc Blocking
Voltage per element at 25 ¢J
10.0
See Fig 4
at100 ¢J
1.0
I²t Rating for fusing ( t<8.3ms)
166
Typical junction capacitance per leg (Note 4) CJ
200
Typical Thermal Resistance per leg (Note 3) R £KJA
21
Typical Thermal Resistance per leg (Note 2) R £KJL
6
Operating Temperature Range
-55 TO +125
Storage Temperature Range
-55 TO +150
CP808
800
560
UNITS
V
V
A
A
A
V
£g A
mA
A²Sec
P^F
¢J /W
¢J
¢J
NOTES:
1. Bolt down on heat-sink with silicon thermal compound between bridge and mounting surface
for maximum heat transfer with #6 screw.
2. Units Mounted on a 8.6”¡Ñ 8.6” ¡Ñ 24” thick (22 ¡Ñ 22 ¡Ñ 0.6cm) AL plate heatsink.
3. Units Mounted on P.C.B at 0.375”(9.5mm) lead length with 0.5 ¡Ñ 0.5”(12 ¡Ñ 12mm)copper pads.
4. Measured at 1.0MHZ and applied reverse voltage.