3.0SMCJ_SERIES_14 Datasheet, PDF (1/7 Pages) Pan Jit International Inc. – SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR PEAK PULSE POWER 3000 Watts

3.0SMCJ SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR PEAK PULSE POWER 3000Watts
STAND-OFF VOLTAGE
5 to 220 Volt
Recongnized File # E210467
FEATURES
• For surface mounted applications in order to optimize board space
• Glass passivated junction
• Low inductance
• Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
• High temperature soldering : 260°C /10 seconds at terminals
• Lead free in compliance with EU RoHS 2011/65/EU directive
• Green molding compound as per IEC61249 Std. . (Halogen Free)
0 . 2 8 0 ( 7 . 11 )
0.260(6.60)
0.012(0.305)
0.006(0.152)
MECHANICAL DATA
• Case: JEDEC DO-214AB,Molded plastic over passivated junction.
• Terminals: Solder plated,solderable per MIL-STD-750, Method 2026
• Polarity: Color band denotes cathode end
• Standard Packaging: 16mm tape (EIA-481)
• Weight: 0.008 ounce, 0.23 gram
0.050(1.27)
0.030(0.76)
0.008(0.203)
0.002(0.051)
0.320(8.13)
0.305(7.75)
DEVICES FOR BIPOLARAPPLICATIONS
For Bidirectional use C or CA Suffix for types 3.0SMCJ5.0 thru types 3.0SMCJ220.
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
Rating
Peak Pulse Power Dissipation on 10/1000μs waveform (Notes 1,2, Fig.1)
Peak Forward Surge Current 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method) (Notes 2,3)
Peak Pulse Current on 10/1000μs waveform (Notes 1) Fig.3
Typical Thermal Resistance Junction to Air
Operating Junction and Storage Temperature Range
Symbol
PPP
IFSM
IPPM
R_θJA
TJ,TSTG
Value
3000
200
see Table 1
25
-55 to +150
Units
Watts
Amps
Amps
O_{C / W}
O_C
NOTES:
1.Non-repetitive current pulse, per Fig. 3 and derated above T_A=25°C per Fig. 2.
2.Mounted on 8mm² ( .013mm thick) land areas.
3.Measured on 8.3ms , single half sine-wave or equivalent square wave , duty cycle= 4 pulses per minute s maximum.
4.A transient suppressor is selected according to the working peak reverse voltage (VRWM), which should be equal to or greater than the DC
or continuous peak operating voltage level.
November 2,2012-REV.10
PAGE . 1