1.5SMCJ-AU Datasheet, PDF (1/7 Pages) Pan Jit International Inc. – SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR PEAK PULSE POWER 1500 Watt

1.5SMCJ-AU SERIES
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR PEAK PULSE POWER 1500 Watt
STAND-OFF VOLTAGE
5 to 220 Volt
Recongnized File # E210467
FEATURES
• For surface mounted applications in order to optimize board space.
• Glass passivated junction
• Low inductance
• Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
• High temperature soldering : 260°C /10 seconds at terminals
• Acquire quality system certificate : TS16949
• AEC-Q101 qualified
• ESD IEC-61000-4-2 Air + 30kV, Contact + 30kV
• Lead free in compliance with EU RoHS 2011/65/EU directive
• Green molding compound as per IEC61249 Std. . (Halogen Free)
MECHANICAL DATA
• Case: JEDEC DO-214AB,Molded plastic over passivated junction.
• Terminals: Solder plated,solderable per MIL-STD-750, Method 2026
• Polarity: Color band denotes cathode end
• Standard Packaging: 16mm tape (EIA-481)
• Weight: 0.008 ounce, 0.023 gram
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types 1.5SMCJ5.0 thru types 1.5SMCJ220.
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
Rating
Symbol
Value
Peak Power Dissipation at T_A=25^OC, tp=1ms (Notes 1)
P_PP
1500
Peak Pulse Current on tp=10/1000μs waveform (Notes 1)
I_PPM
See table
Typical Thermal Resistance Junction to Air (Notes 2)
Peak Forward Surge Current, 8.3ms Single Half Sine-Wave
Superimposed on Rated Load (Notes 3)
ESD IEC-61000-4-2 (Air)
ESD IEC-61000-4-2 (Contact)
Operating Junction and Storage Temperature Range
R_θJA
I _FSM
VESD
T_J,T_STG
50
200
+30
+30
-55 to +150
Units
W
A
O_{C / W}
A
kV
O_C
NOTES :
1.Non-repetitive current pulse, per Fig. 3 and derated above T_A=25°Cper Fig. 2.
2.Mounted on 2mm ² (0.013mm thick) land areas.
3.Measured on 8.3ms, single hal f sine-wave or equivalent s quare wave, duty cycle= 4 pulse s per minutes maxi mum.
4.A transient suppressor is selected according to the working peak reverse voltage (VRWM), which should be equal to or greater than the DC
or continuous peak operating voltage level.
November 23,2015-REV.06
PAGE . 1