1.5SMC-AU Datasheet, PDF (1/7 Pages) Pan Jit International Inc. – GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR PEAK PULSE POWER 1500 Watt

1.5SMC-AU SERIES
GLASS PASSIVATED JUNCTION TRANSIENT VOLTAGE SUPPRESSOR PEAK PULSE POWER 1500 Watt
BREAK DOWN VOLTAGE
6.8 to 250 Volt
FEATURES
• Plastic package has Underwriters Laboratory Flammability
Classification 94V-O
• Glass passivated chip junction in SMC/DO-214AB package
• 1500W surge capability at 1ms
• Excellent clamping capability
• Low zener impedance
• Fast response time: typically less than 1 ps from 0 volts to BV min
• High temperature soldering guaranteed: 260°C/10 seconds/0.375",(9.5mm)
lead length/5lbs., (2.3kg) tension
• Acqire quality system certificate : TS16949
• AEC-Q101 qualified
• ESD IEC-61000-4-2 Air + 30kV, Contact + 30kV
• Lead free in compliance with EU RoHS 2011/65/EU directive
• Green molding compound as per IEC61249 Std. . (Halogen Free)
MECHANICAL DATA
• Case: JEDEC SMC/DO-214AB molded plastic
• Terminals: Solderable per MIL-STD-750, Method 2026
• Polarity: Color band denotes cathode end
• Weight: 0.0082 ounce, 0.233 gram
DEVICES FOR BIPOLAR APPLICATIONS
For Bidirectional use C or CA Suffix for types 1.5SMC6.8 thru types 1.5SMC250.
Electrical characteristics apply in both directions.
MAXIMUM RATINGS AND CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified.
Rating
Symbol
Value
Units
Peak Power Dissipation at T =25OC, tp=1ms (Notes 1)
A
P
1500
Watts
PP
Typical Thermal Resistance Junction to Air (Notes 2)
R_θJA
50
O_{C / W}
Peak Pulse Current on tp=10/1000μs waveform (Notes 1)
Peak Forward Surge Current, 8.3ms Single Half Sine-Wave
Superimposed on Rated Load (Notes 3)
ESD IEC-61000-4-2 (Air)
ESD IEC-61000-4-2 (Contact)
Operating Junction and Storage Temperature Range
I_PPM
I _FSM
VESD
T_J,T_STG
see Table
200
+30
+30
-55 to +150
Amps
Amps
kV
O_C
NOTES :
1. Non-repetitive current pulse, per Fig. 3 and derated above T_A=25°C per Fig. 2.
2. Mounted on Copper Leaf area of 0.79 in²(20mm²).
3. 8.3ms single half sine-wave, duty cycle= 4 pulses per minutes maximum.
4. A transient suppressor is selected according to the working peak reverse voltage (VRWM), which should be equal to or greater than the DC
or continuous peak operating voltage level.
November 23,2015-REV.09
PAGE . 1