D-300-08 Datasheet, PDF (5/7 Pages) PANDUIT CORP. – CAP, SPLICE ENCAPSULATION

CUSTOMER DRAWING
TABLE 1
REQUIREMENTS FOR MOLDED COMPONENT
Property
Tensile Strength
Ultimate Elongation
Stiffness
Specific Gravity
Hardness
Low Temperature Flexibility
4 hours @ -55°C (-67°F)
Heat Shock
4 hours @ 225°C (437°F)
Heat Aging
Followed by test for:
Tensile Strength
Ultimate Elongation
Flammability
Fungus Resistance
Water Absorption
24 hours @ 25° C (77°F)
Solvent Resistance
24 hours @ 25°C (77°F) in
JP-4 Fuel
Skydrol* 500
Hydraulic Fluid (MIL-H-5606)
Aviation Gasoline (100/130)
Water
Unit
psi
percent
psi
Shore D
psi
percent
percent
Requirement
1500 minimum
250 minimum
10,000 minimum
25,000 maximum
1.40 maximum
50±10
No cracking
Method of Test
Section 4.3.1
(ASTM D 412)
ASTM D 747
ASTM D 792
ASTM D 2240
Section 4.3.2
No Dripping, flowing or
cracking
Section 4.3.3
Section 4.3.4
Procedures A and B
1200 minimum
200 minimum
Non-burning
Rating of 1 or less
0.2 maximum
Section 4.3.1
(ASTM D 412)
ASTM D 635
ASTM D 876
ASTM D 570
Procedure A
Section 4.3.5
Followed by test for:
Tensile Strength
Ultimate Elongation
psi
percent
1200 minimum
200 minimum
Section 4.3.1
(ASTM D 412)
Tyco Electronics
305 Constitution Dr
Menlo Park, CA
94025, U.S.A.
TITLE:
CAP, SPLICE ENCAPSULATION
Unless otherwise specified dimensions are in millimeters.
Raychem
[Inches dimensions are shown in brackets]
Devices
TOLERANCES: ANGLES: N/A Tyco Electronics reserves the right to
0.00 N/A
amend this drawing at any time. Users
0.0 N/A
0 N/A
ROUGHNESS
IN MICRON
should evaluate the suitability of the
product for their application.
DRAWN BY:
CAGE CODE: REPLACES:
ECO NUMBER:
M. FORONDA
06090
D010044
08-018889
DOCUMENT NO.:
D-300-08/-12/-18
REV:
SCALE:
B
NTS
DATE:
SIZE:
A
31-July-08
SHEET:
5 of 7
© 2008 Tyco Electronics Corporation. All rights reserved
If this document is printed it becomes uncontrolled. Check for the latest revision.