S-2L2-48V Datasheet, PDF (5/5 Pages) Panasonic Semiconductor – 4 AMP POLARIZED HIGH DENSITY RELAY

S
Inserting and removing method
Inserting method: Insert the relay as shown in
Fig. 1 unit the rib of the relay snaps into the
clip of the socket.
Rib
Fig. 1
Removing method:
(1) Remove the relay straight from the
socket holding the shaded portion of the
relay as shown in Fig. 2.
(2) When sockets are mounted in close
proximity, use a slotted screw driver as
shown in Fig. 3.
Fig. 2
Fig. 3
NOTES
1. Special use of 2 coil latching types: 2
ways can be considered if 2 coil latching
types are used as 1 coil latching types.
(A) Reverse polarity is applied to the set
coil of 2 coil latching type.
(B) By shorting terminals 12 and 7, apply
plus to 1, minus to 6 at set and plus to 6,
minus to 1 at reset. Applied coil voltage
should be the same as the nominal. Ope-
rating power will be reduced to one-half.
Reset position of 2a2b type
123456
-
+
12 11 10 9 8
7
CAUTIONS FOR USE
Based on regulations regarding insulation distance, there is a re-
striction on same-channel load connections between terminals
No. 2, 3 and 4, 5, as well as between No. 8, 9 and 10, 11. See the
figure below for an example.
23
11 10
2. Soldering operations should be accom-
plished as quick as possible; within 10
seconds at 250°C 482°F solder tempera-
ture or 3 seconds at 350°C 662°F. The
header portion being sealed with epoxy
resin, undue subjection to heat may
cause loss of seal. Solder should not be
permitted to remain on the header.
45
98
23
45
11 ₁₀
98
• Between 2, 3 and 4, 5: different channels, therefore not possible
• Between 10, 11 and 8, 9: different channels, therefore not possible
No good
• Between 2, 3 and 4, 5: same channels, therefore possible
• Between 10, 11 and 8, 9: same channels, therefore possible
Good
For Cautions for Use, see Relay Technical Information (Page 48 to 76).
223