ERQ14AJ101P Datasheet, PDF (5/8 Pages) Panasonic Semiconductor – Metal Film Fusing Resistors, ERQA, Z

■ Performance Specifications
Characteristics
Specifications
Metal Film
Fusing Resistors, ERQA, Z
Test Methods
Fusing
Characteristics
Rated Res. Value
Power
(ȑ)
Limit
0.25 W
0.5 W
1 to 1.8
1W
2W
Open within
30 seconds
at 30 times
the rated
power
Open within
30 seconds
at 25 times
the rated
power
0.25 W
0.5 W
1W
2W
0.25 W
0.5 W
1W
2W
2 to 9.1
10 to 470
10 to 560
Open within
30 seconds
at 16 times
the rated
power
Open within
30 seconds
at 12 times
the rated
power
The test potential shall be preadjusted using a dummy
resistor and then be subjected to the test specimens.
The potential shall be readjusted within two seconds to
reach the exact value of specified current. This test
shall be made under the conditions at 20 °C and 65 %
RH (or at a temperature of 5 °C to 35 °C and 45 to
85 % RH, only when any doubt may not be caused),
and the use of stabilized power source is suggested.
Fusing time shall be measured as the duration until the
circuit current is decreased to a 1/50 the initial test
current or less.
Design and specifications are each subject to change without notice. Ask factory for the current technical specifications before purchase and/or use.
Should a safety concern arise regarding this product, please be sure to contact us immediately.
Feb. 2006