MN101EF34D Datasheet, PDF (2/4 Pages) Panasonic Semiconductor – MN101EF34D

MN101EF34D
Timer counter 8 : 16 bit × 1
(square-wave output, PWM output (cycle / duty continuous variable), event count, pulse width measurement, input
capture)
(square-wave/PWM output to large current terminal P01 (TM8IOB) possible)
Clock source................ 1/1, 1/2, 1/4, 1/16 of system clock frequency; 1/1, 1/2, 1/4, 1/16 of OSC oscillation clock frequency; 1/1,
1/2, 1/4, 1/16 of external clock input frequency
Interrupt source ........... coincidence with compare register 8 (2 lines), input capture register
Timer counter 9 : 16 bit × 1
(square-wave output, PWM output (cycle / duty continuous variable), event count, pulse width measurement, input
capture)
Clock source................ 1/1, 1/2, 1/4, 1/16 of system clock frequency; 1/1, 1/2, 1/4, 1/16 of OSC oscillation clock frequency; 1/1,
1/2, 1/4, 1/16 of external clock input frequency
Interrupt source ........... coincidence with compare register 9 (2 lines), input capture register
Time base timer (one-minute count setting)
Clock source................ 1/1 of OSC oscillation clock frequency; 1/1 of XI oscillation clock frequency
Interrupt source ........... 1/128, 1/256, 1/512, 1/1024, 1/4096, 1/8192, 1/16384, 1/32768 of clock source frequency
Watchdog timer
Interrupt source ........... 1/65536, 1/262144, 1/1048576 of system clock frequency
 Serial interface
Serial 1 : synchronous type/UART (full-duplex) × 1
Clock source................ 1/2, 1/4 of system clock frequency; pulse output of timer counter 1 or 2; 1/2, 1/4, 1/16, 1/64 of OSC
oscillation clock frequency, external clock
Serial 2 : synchronous type/UART (full-duplex) × 1
Clock source................ 1/2, 1/4 of system clock frequency; pulse output of timer counter 1 or 2; 1/2, 1/4, 1/16, 1/64 of OSC
oscillation clock frequency, external clock
Serial 4 : synchronous type/multi-master I²C × 1(applicable for 7-bit/10-bit address setting, general call)
 I/O Pins
I/O
39
Common use , Specified pull-up resistor available, Input/output selectable (bit unit)
 A/D converter
10-bit × 8-ch. (with S/H)
 Special Ports
Buzzer output, remote control carrier signal output, high-current drive port, clock output
 ROM Correction
Correcting address designation : up to 7 addresses possible
 Development tools
In-circuit Emulator (Under development)
MAD00060AEM