MN101C49H Datasheet, PDF (2/4 Pages) Panasonic Semiconductor – MN101C49H

MN101C49G, MN101C49H, MN101C49K
Timer counter 7 : 16-bit × 1
(square-wave/16-bit PWM output, cycle / duty continuous variable, event count, synchronous output evevt, pulse width
measurement, input capture)
Clock source................ 1/1, 1/2, 1/4, 1/16 of system clock frequency; 1/1, 1/2, 1/4, 1/16 of OSC oscillation clock frequency; 1/1,
1/2, 1/4, 1/16 of external clock input frequency
Interrupt source ........... coincidence with compare register 7 (2 lines)
Time base timer (one-minute count setting)
Clock source................ 1/1 of OSC oscillation clock frequency; 1/1 of XI oscillation clock frequency
Interrupt source ........... 1/128, 1/256, 1/512, 1/1024, 1/8192, 1/32768 of clock source frequency
Watchdog timer
Interrupt source ........... 1/65536, 1/262144, 1/1048576 of system clock frequency
 Serial interface
Serial 0 : synchronous type/UART (full-duplex) × 1
Clock source................ 1/2, 1/4 of system clock frequency; pulse output of timer counter 2, 4; 1/2, 1/4, 1/16, 1/64 of OSC
oscillation clock frequency
Serial 1 : synchronous type/simple UART (half-duplex) × 1
Clock source................ 1/2, 1/4 of system clock frequency; pulse output of timer counter 4; 1/2, 1/4, 1/16, 1/64 of OSC oscillation
clock frequency
Serial 2 : synchronous type × 1
Clock source................ 1/2, 1/4 of system clock frequency; pulse output of timer counter 3; 1/2, 1/4, 1/16, 1/32 of OSC oscillation
clock frequency
Serial 3 : synchronous type/single-master I²C × 1
Clock source................ 1/2, 1/4 of system clock frequency; pulse output of timer counter 3; 1/2, 1/4, 1/16, 1/32 of OSC oscillation
clock frequency
 DMA controller
Max. Transfer cycles : 255
Starting factor : external request, various types of interrupt, software
Transfer mode : 1-byte transfer, word transfer, burst transfer
 I/O Pins
I/O
Input
73
Common use , Specified pull-up resistor available, Input/output selectable (bit unit)
(72) ( ) : Flash memory built-in type.
15
Common use , Specified pull-up resistor available
(14) ( ) : Flash memory built-in type.
 A/D converter
10-bit × 8-ch. (with S/H)
 D/A converter
8-bit × 4-ch.
 Special Ports
Buzzer output, remote control carrier signal output, high-current drive port
 ROM Correction
Correcting address designation : up to 3 addresses possible
MAD00011HEM