EZA-EGCA50AV Datasheet, PDF (2/2 Pages) Panasonic Semiconductor – ESD Suppressor Array

ESD Suppressor Array
■ Ratings
Type
(inch size)
Capacitance⁽¹⁾
Peak Voltage⁽²⁾
Clamping
Voltage⁽³⁾
Rated
Voltage⁽⁴⁾
Rated Current⁽⁵⁾ Category Temperature Range
EZAEGCA
(0805)
0.25+0.05/-0.10pF
500 V max.
(350 V typ.)
100 V max. 15 V max.
100 mA max.
–55 to +125 °C
(1) Capacitance = The capacitance value shall be measured under the conditions specified below.
Frequency : 1 MHz±10 %, Voltage : 1 Vrms±0.2 Vrms, Temperature : 25 °C±2 °C
(2) Peak Voltage = The peak voltage value shall be measured under the following conditions. ESD test conditions : IEC61000-4-2, 8 kV contact discharge
(3) Clamping Voltage = The clamping voltage value shall be measured at 30 ns after initiation of pulse and measured under the conditions specified below.
ESD test conditions : IEC61000-4-2, 8 kV contact discharge
(4) Rated voltage between I/O terminal and GND.
(5) Rated current between input terminal and output terminal.
■ Typical Circuits Requiring Protection
● HDMI circuit
HDMI Controller
)%.*
3Y5Y
■ ESD Suppression Voltage Waveform
400
350
300
250
200
150
100
50
0
-50-20 ₀
20 40 60 80 100 120 140 160 180 200
Times (nSecs)
■ Recommended Land Pattern
Recommended land pattern design for ESD Suppressor Array is shown below.
bg
P
-BOE
QBUUFSO
a
b
c
d
Dimensions
(mm)
0.75
0.25
1.70
0.35
c
e
h
g
P
h
Dimensions
(mm)
1.85
2.60
0.25
0.50
■ Packaging Methods, Soldering Conditions and Safety Precautions
Please see Data Files
Design and specifications are each subject to change without notice. Ask factory for the current technical specifications before purchase and/or use.
Should a safety concern arise regarding this product, please be sure to contact us immediately.
01 Nov. 2012