ERJM1W Datasheet, PDF (11/11 Pages) Panasonic Semiconductor – Low Resistance Value Chip Resistor

Subject
Low Resistance Value Chip Resistor
Part No.
ERJM1W
Spec. No.
151-RJM-E2W00A
10 - 11
3. Specifications
3-1 Specifications of Taping
• When the test shall be operated with the below conditions, the peel strength shall
be 0.098N to 0.686N and the tape shall not have flash and tear after peeling.
<Test Method>
Carrier Tape
Peeling Direction
10°
Top Tape
• Minimum Bending Radius
When the carrier tape shall be bent to Minimum Bending Radius (15mm), there
shall be no defection of chip and no break of the carrier tape. However the test
shall be done for 1 time.
• Resistance to climate
When resistors shall be exposed at 60deg.C, 90 to 95 %RH for 120 hours, there
shall be no defection of chip and no break of carrier tape. When the top tape
shall be peeled, it shall not have flash and tear.
3-2 Quantity in Reel : 3000 pcs./reel
3-3 Taping Condition
• Chip resistors shall not be sticking to top tape and bottom tape.
• Chip resistors shall be easy to take out from carrier tape.
• Compartment and sprocket hole shall not have flash and break.
4. Outer Packaging
Tape
Marking
• When reels shall not reach Max. quantity, the remaining empty space shall be
buried with buffer material.
• When the quantity shall be few, alternative packaging methods may be used. No
problem must occur during the exportation of the product.
5. Marking
• Side of Reel(Marking shall be on one side.)
1) Part Name('Fixed metal plate flat chip resistor' following part name on invoice)
2) Part Number 3) Quantity 4) Lot Number 5) Maker Name
6) Manufacturing Country
• Packaging Box
1) Part Number 2) Quantity 3) Maker Name
PANASONIC ELECTRONIC DEVICES CO.,LTD.