MN101E16 Datasheet, PDF (1/3 Pages) Panasonic Semiconductor – Buzzer output. High-current drive port

MN101E16 Series
Type
Internal ROM type
ROM (byte)
RAM (byte)
Package (Lead-free)
Minimum Instruction
Execution Time
MN101E16K
MN101E16Y
MN101EF16K
MN101EF16Z
Mask ROM
FLASH
256K
384K
260K
512K
12K
20K
16K
30K
LQFP100-P-1414,
QFP100-P-1818B
QFP100-P-1818B
LQFP100-P-1414,
QFP100-P-1818B
QFP100-P-1818B
0.0588 µs (at 2.7 V to 3.6 V, 17 MHz, at internal 2, 4, 8 times oscillation))
0.1 µs (at 2.7 V to 3.6 V, 20 MHz)
30.6 µs (at 2.7 V to 3.6 V, 32.768 kHz)
 Interrupts
RESET. Watchdog. External 0 to 5. Timer 0 to 3. Timer 6. Timer 7 (2 systems). Timer A to E.Time base. Serial 0 (2 systems). Serial 1 (2
systems). Serial 2. Serial 3 (2 systems). Serial 4 (2 systems). Automatic transfer finish (2 systems). A/D conversion finish. Key interrupt
 Timer Counter
8-bit timer × 10
Timer 0 ..................Square-wave/8-bit PWM output. Event count. Pulse width measurement. Real time output control
Timer 1 ..................Square-wave output. Event count. Synchronous output event
Timer 2 ..................Square-wave/8-bit PWM output. Event count. Synchronous output event. Pulse width measurement. Real time
output control. Serial baud rate timer
Timer 3 ..................Square-wave output. Event count. Serial baud rate timer
Timer 6 ..................8-bit freerun timer. Time base timer
Timer A, B, C, D, E
Timer 0, 1 can be cascade-connected
Timer 0, 1, 2 can be cascade-connected
Timer 2, 3 can be cascade-connected
Timer 0, 1, 2, 3 can be cascade-connected
16-bit timer × 1
Timer 7 ..................Square-wave/16-bit PWM output (cycle/duty continuous variable). Event count. Synchronous output event. Pulse
width measurement. Input capture
Time base timer: One-minute count setting
Watchdog timer × 1
 Serial interface
Synchronous type/UART (full-duplex) × 3: Serial 0, 1, 4
Synchronous type/Single-master I²C × 1: Serial 2
Synchronous type/I²C × 1: Serial 3
 DMA controller
Number of channels: 2 channels
Maximum transfer cycles: 255
Starting factor: External request. Various types of interrupt. Software
Transfer mode: 1-byte transfer. Word transfer. Burst transfer
 I/O Pins
I/O
22 : (5 V I/F port) Common use. Specified pull-up resistor available. Input/output selectable (bit unit)
62 : (3 V I/F port) Common use. Specified pull-up resistor available. Input/output selectable (bit unit)
1 : (3 V I/F port) Common use
 A/D converter
10-bit × 8 channels (with S/H)
 Special Ports
Buzzer output. High-current drive port
 ROM Correction
Correcting address designation: Up to 7 addresses possible
MAD00046LEM