MN101C94A Datasheet, PDF (1/3 Pages) Panasonic Semiconductor – MN101C94D

MN101C94A
Type
Internal ROM type
ROM (byte)
RAM (byte)
Package (Lead-free)
Minimum Instruction
Execution Time
MN101C94A
MN101CF94D
Mask ROM
FLASH
32K
64K
1K
2K
QFP044-P-1010F
0.10 µs (at 4.5 V to 5.5 V, 20 MHz)
0.238 µs (at 2.7 V to 5.5 V, 8.39 MHz)
0.477 µs (at 2.0 V to 5.5 V, 4.19 MHz)*
* The lower limit for operation guarantee for flash memory built-in type is 2.5 V.
 Interrupts
RESET, Watchdog, External 0 to 2, Timer 0 to 5, Time base, Serial 0, A/D conversion finish
 Timer Counter
Timer counter 0 : 8-bit × 1 (square-wave/8-bit PWM output, event count, generation of remote control carrier)
Clock source................ 1/1, 1/4 of system clock frequency; 1/1 of OSC oscillation clock frequency; external clock input
Interrupt source ........... coincidence with compare register 0
Timer counter 1 : 8-bit × 1 (square-wave output, event count, synchronous output event)
Clock source................ 1/16, 1/64 of system clock frequency; external clock input
Interrupt source ........... coincidence with compare register 1
Timer counter 0, 1 can be cascade-connected.
Timer counter 2 : 8-bit × 1 (square-wave/8-bit PWM output, event count, synchronous output event)
Clock source................ 1/1, 1/4 of system clock frequency; external clock input
Interrupt source ........... coincidence with compare register 2
Timer counter 3 : 8-bit × 1
(square-wave output, event count, generation of remote control carrier, serial 0 baud rate timer)
Clock source................ 1/4, 1/16 of system clock frequency; 1/1 of OSC oscillation clock frequency; external clock input
Interrupt source ........... coincidence with compare register 3
Timer counter 2, 3 can be cascade-connected.
Timer counter 4 : 16-bit × 1 (square-wave/16-bit PWM output, event count, synchronous output event, input capture)
Clock source................ 1/4, 1/16 of system clock frequency; 1/1 of OSC oscillation clock frequency; external clock input
Interrupt source ........... coincidence with compare register 4
Time base timer (one-minute count setting, independently operable 8-bit timer counter 5)
Clock source................ 1/4 of system clock frequency; 1/1, 1/8192 of OSC oscillation clock frequency
Interrupt source ........... coincidence with compare register 5; 1/8192 prescaler overflow
Watchdog timer
Interrupt source ........... 1/1048576 of system clock frequency
 Serial interface
Serial 0 : synchronous type/simple UART (half-duplex) × 1
Clock source................ 1/2, 1/4, 1/16 of system clock frequency; output of timer counter 3
 I/O Pins
I/O
Input
26
Common use : 17, Specified pull-up resistor available
Input/output selectable (bit unit) : 26
11
Common use, Specified pull-up resistor available
 A/D converter
10-bit × 8-ch. (with S/H)
 Special Ports
Buzzer output, remote control carrier signal output, high-current drive port
MAD00052CEM