MN101C78 Datasheet, PDF (1/3 Pages) Panasonic Semiconductor – MN101C78 Series

MN101C78 Series
Type
Internal ROM type
ROM (byte)
RAM (byte)
Package (Lead-free)
Minimum Instruction
Execution Time
MN101C78A
MN101CF78A
Mask ROM
FLASH
32K
1.5K
TQFP048-P-0707B
0.100 µs (at 3.0 V to 3.6 V, 10 MHz)
0.118 µs (at 2.7 V to 3.6 V, 8.5 MHz)
0.235 µs (at 1.8 V to 3.6 V, 4.25 MHz)*
62.5 µs (at 1.8 V to 3.6 V, 32 kHz)*
*: The lower limit for operation guarantee for flash memory built-in type is 2.2 V.
 Interrupts
RESET. Watchdog. External 0 to 2. External 4 (key interrupt dedicated). Timer 0 to 3. Timer 6. Timer 7 (2 systems). Timer 8 (2 systems).
Time base. Serial 0 (2 systems). Serial 1 (2 systems). Serial 3. Serial 4. A/D conversion finish
 Timer Counter
8-bit timer × 5
Timer 0 ..................Square-wave/8-bit PWM output. Event count. Remote control carrier output. Simple pulse width measurement.
Added pulse (2-bit) type PWM output. Real time output control. Square-wave/PWM output to large current
terminal P50 possible
Timer 1 ..................Square-wave output. Event count. Synchronous output event
Timer 2 ..................Square-wave output. Added pulse (2-bit) type PWM output. PWM output. Serial transfer clock output. Real time
output control. Event count. Synchronous output event. Simple pulse width measurement. Square-wave/PWM
output to large current terminal P52 possible
Timer 3 ..................Square-wave output. Event count. Remote control carrier output. Serial 0 baud rate timer
Timer 6 ..................8-bit freerun timer
Timer 0, 1 can be cascade-connected
Timer 2, 3 can be cascade-connected
16-bit timer × 2
Timer 7 ..................Square-wave output. 16-bit PWM output (cycle/duty continuous variable). Event count. Synchronous output
event. Pulse width measurement. Input capture. Real time output control. High performance IGBT output. Square-
wave/PWM output to large current terminal P51 possible
Timer 8 ..................Square-wave/16-bit PWM output (duty continuous variable). Event count. Pulse width measurement. Input
capture. Square-wave/PWM output to large current terminal P53 possible
Timer 7, 8 can be cascade-connected: Square-wave output, PWM, input capture, pulse width measurement is possible as a 32-bit
timer
Time base timer: One-minute count setting
Watchdog timer × 1
 Serial interface
Synchronous type/UART (full-duplex) × 2: Serial 0, 1
Synchronous type/Single-master I²C × 1: Serial 3
I²C slave × 1: Serial 4
Serial 4...................I²C high-speed transfer mode. 7-bit/10-bit address setting. General call
 I/O Pins
I/O
39 : Common use. Specified pull-up resistor available. Input/output selectable (bit unit)
 A/D converter
10-bit × 7 channels (with S/H)
 Display control function
LCD: 12 segments × 4 commons (Static, 1/2, 1/3, or 1/4 duty)
Usable if VLCD ≤ VDD
 Special Ports
Buzzer output. Inverted buzzer output. Remote control carrier output. High-current drive port
MAD00039GEM