ET-PFD510 Datasheet, PDF (1/1 Pages) Panasonic Semiconductor – Mounting should be done by a qualified technician.

SPEC
Frame
FILE
ET-PFD510
Description
This frame is designed especially for use on the Panasonic’s applicable projector. The frame can also be used for a
dual stack configuration in which two projectors are used together.
Specifications
Dimensions (W × H × D):
Weight*:
Applicable projector:
712 × 408.5 × 932 mm
(28-1/32 × 16-3/32 × 36-11/16 inches)
Approximately 19.4 kg (42.8 lbs)
PT-DZ21K/DS20K/DW17K
* ^{Average value. May differ depending on the actual unit.}
Parts
Frame (already assembled) . . . . . . . . . . . . . . . . . 1
Washer-fitted hexagonal bolts (M6 × 30) . . . . . . 6
Hex bolts (M10 × 140) . . . . . . . . . . . . . . . . . . . . 4
Adjustment nuts (M10) . . . . . . . . . . . . . . . . . . . . 4
Spring washers (M10) . . . . . . . . . . . . . . . . . . . . . 8
Washers (M10) . . . . . . . . . . . . . . . . . . . . . . . . . 16
Hexagonal nuts (M6) . . . . . . . . . . . . . . . . . . . . . . 8
Square washers . . . . . . . . . . . . . . . . . . . . . . . . 16
Caution:
• Mounting should be done by a qualified technician.
• Make sure that the mounting (ceiling) area has sufficient strength.
• Read the enclosed mounting instructions thoroughly before starting.
• Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque
wrench and tighten screws to the torque specified in the instructions.
• When the product is no longer going to be used, have it disposed of quickly by a professional disposal service.
Dimensions
Illustration shows the frame attached to a projector.
712 ( 28-1/32)
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Weights and dimensions shown are approximate. Specifications subject to change without notice.
As of May 2012
SFD12A012
1/1