ET-MDNHM10 Datasheet, PDF (1/1 Pages) Panasonic Semiconductor – Interface Board for HDMI 2 input

SPEC
FILE
Interface Board for HDMI 2 input
ET-MDNHM10
Description
This is an input board for mounting to the PT-RQ13K 3-chip DLP™ projector, and it allows input of two HDMI signal systems.
* This unit does not operate as a stand-alone unit. Use it by mounting to the PT-RQ13K 3-chip DLP™ projector ( sold separately ).
* It is recommended that installation and removal of the interface board for the main projector unit should be carried out by a qualified
technician. Please contact the place of purchase.
Specifications ( Specifications and appearance are subject to change for improvement without notice. )
Compatible slot :
SLOT NX specifications
Terminals :
HDMI 19-pin ×2
[Digital signal] HDCP 2.2 compatible,Deep color compliant, for single link only
Compatible frequencies :
• Resolution
Movie signal resolution : 480i*¹/576i*¹~ 4,096 x 2,160
Still picture signal resolution : 640 x 400~2,560 x 1,600( non-interlace )
• Dot clock frequency : 25 MHz~594 MHz
Dimensions ( W × H × D ) :
Weight :
151 × 38.5 × 142 mm ( 5-15/16˝ × 1-17/32˝ × 5-19/32˝ )
Approx. 350 g*² ( 12.3 oz*² )
Applicable projector :
PT-RQ13K (As of November 2015)
*1 Pixel-Repetition signal (dot clock frequency 27.0 MHz) only.
*2 Average value. May differ depending on models.
Dimensions
NOTE: This illustration is not drawn to scale.
151.1(5-15/16)
As of November 2015
SFL15A018
unit : mm (inch)
1/1