|
EETUQ1C123HJ_08 Datasheet, PDF (1/11 Pages) Panasonic Semiconductor – Snap-in Type | |||
|
Snap-in Type
Series: UQ Type: TS
â Features
â Endurance : 85 °C 2000 h
â 30 % Smaller than series TS-UP
â RoHS directive compliant
Aluminum Electrolytic Capacitors/ UQ
â Speciï¬cations
Category Temp. Range
â40 °C to +85 °C
â25 °C to +85 °C
Rated W.V. Range
16 V.DC to 100 V.DC
160 V.DC to 250 V.DC
315 V.DC to 450 V.DC
Nominal Cap. Range
1000 µF to 100000 µF
270 µF to 3900 µF
82 µF to 1000 µF
Capacitance Tolerance
±20 % (120 Hz/+20 °C)
DC Leakage Current
3ǰ CV (µA) max. After 5 minutes application of rated working voltage at +20 °C
C : Capacitance (µF) V: W.V. (V.DC)
tan δ
Please see the attached standard products list.
Frequency (Hz)
50
60
100
120
500
1 k 10 k to
Frequency Correction
Factor for Ripple Current
16 V.DC to 100 V.DC /C.F.
0.93
0.95
0.99
1.00
1.05
1.08
1.15
160 V.DC to 450 V.DC /C.F. 0.75
0.80
0.95
1.00
1.20
1.25
1.40
After 2000 hours application of DC voltage with speciï¬ed ripple current (< rated DC working
voltage) at +85 °C±2 °C, the capacitors shall meet the following limits.
Endurance
Capacitance change < ±20 % of initial measured value
tan δ
< 200 % of initial speciï¬ed value
DC leakage current < initial speciï¬ed value
Shelf Life
After storage for 1000 hours at +85 °C±2 °C within no voltage applied and then being stabilized
at +20 °C, capacitors shall meet the limits speciï¬ed in Endurance. (With voltage treatment)
â Dimensions in mm (not to scale)
Polarity bar
Sleeve
Vent
(10.0)
2-Ï2.0±0.1
10.0±0.1
(mm)
L+2.0 max.
4.0±0.5
Rated voltage etc. indicate to sleeve.
0.8+â00..21
(ÏD)
Recommended PWB piercing plan
2.0 max. Terminal
(t=0.8)
1.5±0.2
Top of spin
Standard terminal type does not require
terminal trimming process.
Design and speciï¬cations are each subject to change without notice. Ask factory for the current technical speciï¬cations before purchase and/or use.
Should a safety concern arise regarding this product, please be sure to contact us immediately.
Jul. 2008
|
▷ |