EETHC1A123HJ Datasheet, PDF (1/13 Pages) Panasonic Semiconductor – Snap-in Type

Snap-in Type
Series: _HC Type: _TS
■ Features
● Endurance : 105 °C 2000 h
● 30 % smaller than series TS-HB
● RoHS directive compliant
Aluminum Electrolytic Capacitors/ HC
■ Specifications
Category Temp. Range
–40 °C to +105 °C
–25 °C to +105 °C
Rated W.V. Range
10 V.DC to 100 V.DC
160 V.DC to 250 V.DC
315 V.DC to 450 V.DC
Nominal Cap. Range
820 µF to 100000 µF
150 µF to 3300 µF
39 µF to 1000 µF
Capacitance Tolerance
±20 % (120 Hz/+20 °C)
DC Leakage Current
3ǰ CV (µA) max. After 5 minutes application of rated working voltage at +20 °C.
C : Capacitance (µF) V: W.V. (V.DC)
tan δ
Please see the attached standard products list
Frequency (Hz)
50
60
100
120
500
1 k 10 k to
Frequency Correction
Factor for Ripple Current
10 V.DC to 100 V.DC /C.F.
0.93
0.95
0.99
1.00
1.05
1.08
1.15
160 V.DC to 450 V.DC /C.F. 0.75
0.80
0.95
1.00
1.20
1.25
1.40
After 2000 hours application of DC voltage with specified ripple current (< rated DC working voltage)
at +105 °C±2 °C, the capacitors shall meet the following limits.
Endurance
Capacitance change < ±20 % of initial measured value
tan δ
< 200 % of initial specified value
DC leakage current < initial specified value
Shelf Life
After storage for 1000 hours at +105 °C±2 °C within no voltage applied and then being stabilized
at +20 °C, capacitors shall meet the limits specified in Endurance. (With voltage treatment)
■ Dimensions in mm (not to scale)
Polarity bar
Sleeve
Vent
(10.0)
2-φ2.0±0.1
10.0_±0.1
(mm)
L+2.0 max.
4.0±0.5
Rated voltage etc. indicate to sleeve.
0.8^{+–00..21}
(φD)
Recommended PWB piercing plan
2.0 max. Terminal
(t=0.8)
1.5±0.2
Top of spin
Standard terminal type does not require
terminal trimming peocess.
Design and specifications are each subject to change without notice. Ask factory for the current technical specifications before purchase and/or use.
Should a safety concern arise regarding this product, please be sure to contact us immediately.
Jul. 2008