|
EET-HC2V102LF Datasheet, PDF (1/13 Pages) Panasonic Semiconductor – Alumincum Electrolytic Capacitors/HC | |||
|
Snap-in Type
Series: HC Type: TS
Aluminum Electrolytic Capacitors/ HC
Discontinued
â Features
â Endurance : 105 °C 2000 h
â 30 % smaller than series TS-HB
â RoHS directive compliant
â Specifications
Category Temp. Range
Rated W.V. Range
Nominal Cap. Range
Capacitance Tolerance
DC Leakage Current
tan d
Endurance
Shelf Life
â40 °C to +105 °C
10 V.DC to 100 V.DC
160 V.DC to 250 V.DC
â25 °C to +105 °C
315 V.DC to 450 V.DC
820 μF to 100000 μF
150 μF to 3300 μF
39 μF to 1000 μF
±20 % (120 Hz/+20 °C)
3â CV (μA) max. After 5 minutes application of rated working voltage at +20 °C.
C : Capacitance (μF) V: W.V. (V.DC)
Please see the attached standard products list
After 2000 hours application of DC voltage with speciï¬ed ripple current (< rated DC working voltage)
at +105 °C±2 °C, the capacitors shall meet the following limits.
Capacitance change < ±20 % of initial measured value
tan d
< 200 % of initial speciï¬ed value
DC leakage current < initial speciï¬ed value
After storage for 1000 hours at +105 °C±2 °C within no voltage applied and then being stabilized
at +20 °C, capacitors shall meet the limits speciï¬ed in Endurance. (With voltage treatment)
â Frequency correction factor for ripple current
Rated Voltage
50
10 V.DC to 100 V.DC /C.F.
0.93
160 V.DC to 450 V.DC /C.F.
0.75
60
0.95
0.80
Frequency (Hz)
100
120
500
0.99
1.00
1.05
0.95
1.00
1.20
1k
10 k to
1.08
1.15
1.25
1.40
â Dimensions in mm (not to scale)
Polarity bar
Sleeve
Vent
(10.0)
2-02.0±0.1
10.0±0.1
(Unit : mm)
L+2.0 max.
4.0±0.5
Rated voltage etc. indicate to sleeve.
0.8+â00..21
(0D)
Recommended PWB piercing plan
2.0 max. Terminal
(t=0.8)
1.5±0.2
Top of spin
Standard terminal type does not require
terminal trimming peocess.
Design and speciï¬cations are each subject to change without notice. Ask factory for the current technical speciï¬cations before purchase and/or use.
Should a safety concern arise regarding this product, please be sure to contact us immediately.
01 Sep. 2013
â EEE-135 â
|
▷ |