EECSE0H224N Datasheet, PDF (1/1 Pages) Panasonic Semiconductor – Electric Double Layer Capacitors (Gold Capacitor)

Electric Double Layer Capacitors (Gold Capacitor)
Stacked Coin Type
Series : SE Low temperature assured product
Features
● _{Endurance : +70 °C 1000 h}
● _{Category temperature range : –40 °C to +70 °C}
● _{Automatic insertion available}
● _{RoHS compliant}
Recommended applications
● _{Memory back-up for video and audio equipment, cameras, telephones, printers, data terminals,}
rice cookers and intelligent remote controls.
Specifications
Category temp. range
–40 °C to +70 °C
Maximum operating voltage
5.5 V.DC
Nominal cap.range
0.22 F
Characteristics at
low temperature
Capacitance change ±30 % of initial measured value at +20 °C (at –40 °C)
Internal resistance < 7 times of initial measured value at +20 °C (at –40 °C)
After 1000 hours application of 5.5 V.DC at +70 °C, the capacitor shall meet the following limits.
Endurance
Capacitance change ±30 % of initial measured value
Shelf life
Internal resistance < 4 times of initial specified value
After 1000 hours storage at +70 °C without load, the capacitor shall meet the specified
limits for Endurance.
Dimensions in mm(not to scale)
5.4±0.8
P₂
P
P₁ F
–
+
fd
P0
fD0
Dimensions Nominal
Tolerance
△h
△h1
0d
0.55
±0.05
P0
12.7
±0.2
F
5.0
+0.8
–0.2
W
18.0
±0.5
W0
5.5 <
–
–
+
W1
9.0
±0.5
W2
0 to 3.0
–
H0
16.4
±0.5
0D0
4.0
±0.2
P
12.7
±1.0
P1
3.85
±0.50
P2
6.35
±1.00
(Unit : mm)
△h, △h1
H1
0
30.3 >
±1.0
–
Characteristics list
Category
temp.
range
(°C)
Maximum
operating Capacitance
voltage
(F)
(V.DC)
Capacitance
tolerance
(F)
Internal
resistance
(Initial specified value)
(Ω) at 1 kHz
Recommended ^✽1
discharge current
(μA)
–40 to +70 5.5
0.22 0.176 to 0.396 < 75
300 or less
Parts number
EECSE0H224N
Mass
(Reference value)
(g)
Min.
packaging
q'ty
(pcs)
1.0
1000
✽1 The recommended discharge current is a reference value. Please design your equipment (circuit) in consideration of IR drop.
∙ When ordering please observe the minimum packaging quantity.
∙ When the surface mount component goes through UV or a heat oven to affix the adhesive glue, the capacitor’s surface
temperature should not exceed 100 °C for more than 60 seconds (maximum temperature should not exceed 105 °C)
∙ Do not use reflow soldering. Please refer to the page of “Application guidelines”.
Design and specifications are each subject to change without notice. Ask factory for the current technical specifications before purchase and/or use.
Should a safety concern arise regarding this product, please be sure to contact us immediately.
02 Aug. 2016