ECS-T1AZ475R Datasheet, PDF (1/2 Pages) Panasonic Semiconductor – Tantalum Solid Electrolytic Capacitors/TES

Tantalum Solid Electrolytic Capacitors/TES
Surface Mount Type
Series: TES
s Features ^{Low profile}
Height: H=1.2mm max.
s Specifications
Japan
China
Category temp. range
-55 to 125°C
Rated W.V. Range
4 to 16 V .DC
Nominal Cap. Range
0.47 to 15 µ F
Capacitance Tolerance
DC Leakage Current
±20 % (120Hz/20°C)
I < 0.01CV or 0.5 (µA) after 2 minutes application of rated working voltage at 20°C (Whichever is greater)
tanδ
Please see the attached standard products list
Resistance to Soldering Heat The capacitor shall withstand dipping into solder for 5±1 seconds at 260 ±5°C
After 500 hours exposure at 40 °C and 90 to 95 % R.H. without load, the capacitor shall meet
the following limits.
Moisture Resistance
Capacitance change ±10% of initial measured value
tanδ.
< initial specified value, miniatured size : < 150% of initial specified value.
DC leakage current < initial specified value
After 2000 hours application of rated DC working voltage at 85°C or derated voltage at
125°C, the capacitor shall meet the following limits.
Endurance
Capacitance change ±10% of initial measured value
tanδ.
< initial specified value
DC leakage current < 125 % of initial specified value
s Marking
q Size Z
Polarity bar (+ side)
W.V. code
W.V. (V)
code
W.V.code
4 6.3 10 16
GJAC
Cap. code
Capacitance code
Capacitance(µF) 0.47 0.68 1 1.5 2.2 3.3 4.7 6.8 10 15
1st code
S W A E J N SW A E
(Ex.) JE : 6.3V 1.5µF
s Dimensions in mm (not to scale)
(+)
(-)
P
L
P
w1
EIA code Sizecode L±0.2 W1±0.2 W2±0.1 H max. P
2012
Z
2.0 1.25 0.9 1.2 0.5±0.2
s Case size
W.V.(V.DC)
4(0G)
Cap(µF)
0.47 (474)
0.68 (684)
1.0 (105)
1.5 (155)
2.2 (225)
3.3 (335)
4.7 (475)
6.8 (685)
10 (106)
15 (156)
Standard Miniature
Z
Z
Z
Z
Z
6.3(0J)
Standard Miniature
Z
Z
Z
Z
Z
10(1A)
Standard Miniature
Z
Z
Z
Z
Z
16(1C)
Standard
Z
Z
Miniature
Z
Ta
.
TES
Note : 1. ( )indicates W.V. and capacitance code.
2. When selecting W.V. refer to page 20.
3. We recommend current sizes shown in the above table for new design, but conventional case size is available on request.
4. Other rating upon request (voltage, capacitance, tolerance)
Rev.02/04
Design, Specifications are subject to change without notice. Ask factory for technical specifications before purchase and/or use.
Whenever a doubt about safety arises from this product, please inform us immediately for technical consulation without fail.
 EE31 