AN8049SH Datasheet, PDF (1/28 Pages) Panasonic Semiconductor – 1.8-volt 3-channel step-up, step-down, and polarity inverting DC-DC converter control IC

Voltage Regulators
AN8049SH
1.8-volt 3-channel step-up, step-down, and polarity inverting
DC-DC converter control IC
s Overview
The AN8049SH is a three-channel PWM DC-DC
converter control IC that features low-voltage operation.
This IC can form a power supply that provides two step-
up outputs and one step-down or polarity inverted output
with a minimal number of external components. The
AN8049SH features the ability to operate from a supply
voltage as low as 1.8 V, and thus can be operated from
two dry-batteries.
6.5±0.3
24
13
Unit : mm
(0.50)
0° to 10°
1
12
s Features
• Wide operating supply voltage range: 1.8 V to 14 V
(0.50)
0.50
Seating plane
0.2±0.1
• High-precision reference voltage circuit
— V_REF pin voltage: ±1%
— Error amplifier: ±1.5%
SSOP024-P-0300A
• Surface mounting package for miniaturized and thinner power supplies
Package: SSOP-24D
0.5-mm lead pitch
7.8 mm × 6.8 mm × t 1.9 mm
• Supports control over a wide output frequency range: 20 kHz to 1 MHz
• On/off (sequence control) pins provided for each channel for easy sequence control setup
• The negative supply error amplifier supports 0-volt input.
Common-mode input voltage range: − 0.1 V to V_CC −1.4 V
This allows the number of external components to be reduced by two resistors.
• Fixed duty factor: 86%
However, the duty can be adjusted to anywhere from 0% to 100% with an external resistor.
• Timer latch short-circuit protection circuit (charge current: 1.1 µA typical)
• Low input voltage malfunction prevention circuit (U.V.L.O.) (operation start voltage: 1.67 V typical)
• Standby function (active-high control input, standby mode current: 1 µA maximum)
• Alternate package versions also available.
Part No.: AN8049FHN
Package: QFN-24
0.5-mm lead pitch
5.4 mm × 4.4 mm × t 0.8 mm
Seating plane
s Applications
• Electronic equipment that requires a power supply system
1