|
AN8049FHN Datasheet, PDF (1/23 Pages) Panasonic Semiconductor – 1.8-volt 3-channel step-up, step-down, and polarity inverting DC-DC converter control IC | |||
|
Voltage Regulators
AN8049FHN
1.8-volt 3-channel step-up, step-down, and polarity inverting
DC-DC converter control IC
s Overview
The AN8049FHN is a three-channel PWM DC-DC
converter control IC that features low-voltage operation.
This IC can form a power supply that provides two step-
up outputs and one step-down or polarity inverted output
with a minimal number of external components. Minimal
operating supply voltage of this IC is as low as 1.8 V, so
that it can operate from 2 dry-batteries.
And also, it is housed in an ultrathin, 4-directional-
lead SMD-package whose thickness is 0.8 mm maximum
and pin-pitch is 0.5 mm therefore it is most suitable for
making a power supply small and thin.
Unit: mm
5.2±0.2
5.0±0.1
19
13
3-C0.5
20
12
24
1
R0.3
8
7
A
(1.10)
3.0±0.2
, ,, 4.0±0.1
13
19
12
20
, ,, B
8
24
7
1
0.50
0.2±0.1 0.10 M S A B
0.10 S
S
Seating plane
s Features
⢠Wide operating supply voltage range: 1.8 V to 14 V
QFN024-P-0405
⢠High-precision reference voltage circuit
â VREF pin voltage: ±1%
â Error amplifier: ±1.5%
⢠Ultrathin surface mounting package for miniaturized and thinner power supplies
Package: QFN-24
0.5-mm lead pitch
5.4 mm à 4.4 mm à t 0.8 mm
⢠Supports control over a wide output frequency range: 20 kHz to 1 MHz
⢠On/off (sequence control) pins provided for each channel for easy sequence control setup
⢠The negative supply error amplifier supports 0-volt input.
Common-mode input voltage range: â 0.1 V to VCC â1.4 V
This allows the number of external components to be reduced by two resistors.
⢠Fixed duty factor: 86%
However, the duty can be adjusted to anywhere from 0% to 100% with an external resistor.
⢠Timer latch short-circuit protection circuit (charge current: 1.1 µA typical)
⢠Low input voltage malfunction prevention circuit (U.V.L.O.)
(operation start voltage: 1.67 V typical)
⢠Standby function (active-high control input, standby mode current: 1 µA maximum)
s Applications
⢠Electronic equipment that requires a power supply system
1
|
▷ |