PLBTE3030-YD Datasheet, PDF (8/11 Pages) P-tec Corporation – 1 Watt 3030 Top View Surface Mount LED

Cautions
1. Soldering Conditions
Number of reflow process shall be less than 2 times and cooling process to normal temperature is required
between first and Second soldering process.
(Recommended soldering conditions)
2. Static Electricity
a. It is recommended that a wrist band or an anti-electrostatic glove be used when handling the LEDs.
All devices, equipment and machinery must be properly grounded. Damaged LEDs will show some
unusual characteristics such as the forward voltage becomes lower, or the LEDs do not light at the low
current. Criteria: (VF > 2.0V ,at IF=0.5mA)
3. Moisture Proof Package
a. It is recommended that moisture proof package be used
4. Storage
a. Before opening the package, the LEDs should be kept at 30°C or less and 70%RH or less. The LEDs
should be used within a year.
5. After opening the package, The LEDs should be soldered within 24 hours (1days) after opening the package.
6. Cautions
www.p-tec.net
053014 Rev0 MS
Page 8 of 11