PLC3535-WDRGB1 Datasheet, PDF (3/5 Pages) P-tec Corporation – PLCC6 SMD LED

Soldering
Notes:
1. Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be
confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
2. Reflow soldering should not be done more than two times.
3. When soldering, do not put stress on the LEDs during heating.
4. After soldering, do not warp the circuit board
www.p-tec.net
102914 Rev1 MS
Page 3 of 5