|
PLBT5050-WCY23 Datasheet, PDF (10/11 Pages) P-tec Corporation – Square SMD | |||
|
◁ |
Outer diameter of collet should be
larger than the lighting area
Outer diameter of collet
Picture 1ï¼ï ï¼
Picture 2ï¼Ãï¼
3ãHow to set the height of collet
The reason why for top view SMD, the height of collet before it presses
downward will directly affect the quality of products during SMT is that if
the collect go down too much, it will press lens and cause the distortion or
breaking of gold wire. The setting of collet position should follow the
pictures belowed.
No.3ãOther
points
for
Picture
attention
3ï¼ ï
ï¼
Picture 4ï¼Ãï¼
AãNo pressure should be exerted to the epoxy shell of the SMD under high temperature.
BãDo not scratch or wipe the lens since the lens and gold wire inside are rather fragile and cross
out easy to break.
CãLED should be used as soon as possible when being taken out of the original package, and
should be stored in anti-moisture and anti-ESD package.
No.4ãThis usage and handling instruction is only for your reference.
www.p-tec.net
040715 Rev1 JAS
Page 10 of 11
|
▷ |