LF05E2 Datasheet, PDF (4/6 Pages) OSRAM GmbH – LINEARLIGHT FLEX ECO

LINEARLIGHT FLEX ECO | LF05E2 | TECHNICAL DATASHEET
‒ The mounting substrate must have sufficient structural integrity. Take care to completely remove the
protective backing. Once the module is appropriately positioned, pre on the module with about 20N/cm² (refer
to application techniques of 3M adhesive transfer tapes). In difficult cases the use of a prime may help.
‒ Maximum temperature ratings must be kept. Therefore the module may have to be mounted on a metal heat
sink, depending on the individual installation.
‒ The minimum bending radius is 2 cm. The module may be bent over a smaller radius but only in regions of
the circuit board containing electronic components and such bends should be made once and fixed in
position to avoid cyclic fatigue.
‒ Bending is only allowed within the bending axis of the PCB. Bending outside of that leads to torsion which
may cause damage to the module and will lead to failure.
‒ When installing in environments with large variations in temperature (e.g. outdoor applications) and operating
length of more than 2 m, the use of adequate mounting surfaces is necessary. Otherwise it is advisable to
use an additional thicker adhesive tape to absorb the stress of any mismatch in expansion.
Complementary Systems & Accessories
SLIMCONNECT SYSTEM
Description
2pin Feeder
Jumper (board-to-board)
Extension wire 30mm
Extension wire 150mm
Product name
LF-2PIN Flex SC
LF-CONN Flex SC
LF-WIRE-30 FLEX SC
LF-WIRE-150 FLEX SC
Order Code
4008321832436
4008321832467
4008321875587
4008321875563
CONNECT SYSTEM
Description
2pin Feeder
Jumper (10mm extension)
Jumper (150mm extension)
Product name
LF-2PIN FLEX
LF-CONN-10 FLEX
LF-CONN-150 FLEX
Order Code
4008321955326
4008321955333
4008321955340
SLIMTRACK SYSTEM
Description
SLIM TRACK
Mounting Bracket for SLIM TRACK
Clear SLIM TRACK Cover
Diffuse SLIM TRACK Cover
Endcap for Diffuse Cover
Semi-Diffuse SLIM TRACK Cover
Product name
LF-LTS-2100 SLIM TRACK
LF-LTS-MB
LF-LTS COVER C
LF-LTS-COVER-DIFFUSE
LF-LTS-ENDCAP
LF-LTS COVER S
Order Code
4008321978981
4008321979025
4008321790187
4008321979001
4008321979049
4008321790200
Shipping details
10 / 250
25 / 250
100 / 10,000
50 / 5,000
Shipping details
10 / 100
10 / 200
10 / 100
Shipping details
40
35 / 280
40
40
20 / 160
40
Due to the special conditions of manufacturing processes of LED, the typical data of technical parameters can only reflect st atistical figures and do not
necessarily correspond to the actual parameters of each single product which could differ from the typical data.
Subject to change without notice. Errors and omissions excepted.
Version: 2016-04-07
04