821-IF120.0M-C Datasheet, PDF (1/2 Pages) Oscilent Corporation – 120.0 MHz IF SAW Filter

Oscilent Corporation IF SAW Filter | 821-IF120.0M-C
Page 1 of 2
Part Number
821-IF120.0M-C
Package
20 x9.8 SMD
TYPE :
120.0 MHz IF SAW Filter
Application
120.0 MHz IF SAW Filter
IF SAW Filter
Last Modified
Jan. 01, 2007
PART NUMBER :
821-IF120.0M-C
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Center Frequency (Fo)
Insertion Loss
Source Impedance (single ended)*
Load Impedance (single ended)*
Temperature Coefficient
Amplitude Ripple within fo+/-9.75Mhz
1dB Bandwidth
3dB Bandwidth
40dB Bandwidth
Lower Sidelobe
Upper Sidelobe
Absolute Delay at Fo
Group Delay Variation w/ fo+/-9.75Mhz
Minimum
119.9
-
-
-
-
-
-
20.4
-
50
50
-
-
Typical
120.0
21.5
50
50
-72
0.7
20.2
20.5
21.8
-
-
2.3
40
Maximum
120.1
25.5
-
-
-
1.0
-
-
22.0
-
-
-
100
Units
MHz
dB
ohm
ohm
ppm/C
dBp-p
MHz
MHz
MHz
dB
dB
µsec
nsec
*With Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with
different impedance values and/or structures, if necessary.
** Custom SAW IF Filters available. Contact Oscilent for assistance.
PACKAGE OUTLINE (mm)
TEST FIXTURE
L1 = 56nH
L2 = 68nH
C1 = 33pF
C2 = 20pF
Source/Load Impedance = 50 ohms
Pin Descriptions: IN-10, OUT-5, GROUND- 1,2,3,4,6,7,8,9
FREQUENCY RESPONSE