English
Language : 

821-IF115.0M-C Datasheet, PDF (1/2 Pages) Oscilent Corporation – 115MHz IF SAW Filter
Oscilent Corporation IF SAW Filter | 821-IF115.0M-C
Page 1 of 2
Part Number
821-IF115.0M-C
Package
20 x9.8 SMD
TYPE :
115.0 MHz IF SAW Filter
Application
115MHz IF SAW Filter
IF SAW Filter
Last Modified
Jan. 01 2007
PART NUMBER :
821-IF115.0M-C
OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS
PARAMETERS
Center Frequency (Fo)
Insertion Loss
Source Impedance (single ended)*
Load Impedance (single ended)*
Temperature Coefficient
Amplitude Ripple within fo+/-12.49Mhz
1dB Bandwidth
3dB Bandwidth
40dB Bandwidth
Lower Sidelobe
Upper Sidelobe
Absolute Delay
Group Delay Variation
Minimum
114.9
-
-
-
-
-
-
26.1
-
50
50
-
-
Typical
115.0
22.0
50
50
-72
0.65
26.0
26.5
28.6
-
-
1.64
30
Maximum
115.1
24.0
-
-
-
1.0
-
-
29.0
-
-
-
100
Units
MHz
dB
ohm
ohm
ppm/C
dBp-p
MHz
MHz
MHz
dB
dB
µsec
nsec
*With Matching Network (Ref. Testing Environment Circut as shown below). Those impedances could be modified with
different impedance values and/or structures, if necessary.
** Custom SAW IF Filters available. Contact Oscilent for assistance.
PACKAGE OUTLINE (mm)
TEST FIXTURE
L1 = 82nH
L2 = 56nH
Source/Load Impedance = 50 ohms
Pin Descriptions: IN-10, OUT-5, GROUND- 1,2,3,4,6,7,8,9
FREQUENCY RESPONSE