RS1117A Datasheet, PDF (8/13 Pages) Orister Corporation – 1.0A Low Dropout Positive Voltage Regulator

SOT‐89 Dimension
Page No. : 8/13
NOTES:
A. All linear dimensions are in millimeters.
B. This drawing is subject to change without notice.
C. The center lead is in electrical contact with the tab.
D. Body dimensions do not include mold flash or protrusion. Mold flash and protrusion shall not exceed 0.15 per side.
E. Thermal pad contour optional within these dimensions.
F. Falls within JEDEC TO‐243 variation AA, except minimum lead length, pin 2 minimum lead width, minimum tab width.
DS‐RS1117A‐16 September, 2009
www.Orister.com