C-51505NJQJ-LR-AG Datasheet, PDF (11/18 Pages) OPTREX CORPORATION – LCD Module Technical Specification

5.Test
No change on display and in operation under the following test condition.
Conditions:
Unless otherwise specified, tests will be conducted under the following condition.
Temperature: 20±5°C
Humidity : 65±5%RH
tests will be not conducted under functioning state.
No.
Parameter
Conditions
Notes
1
High Temperature Operating 70°C±2°C, 96hrs (operation state)
2
Low Temperature Operating -20°C±2°C, 96hrs (operation state)
1
3
High Temperature Storage
70°C±2°C, 96hrs
2
4
Low Temperature Storage
-20°C±2°C, 96hrs
1,2
5
Damp Proof Test
40°C±2°C,90~95%RH, 96hrs
1,2
6
Vibration Test
Total fixed amplitude : 1.5mm
3
Vibration Frequency : 10~55Hz
One cycle 60 seconds to 3 directions of X, Y, Z for
each 15 minutes
7
Shock Test
To be measured after dropping from 60cm high on
the concrete surface in packing state.
E
B
Dropping method corner dropping
F
A corner : once
GD _C
A
60cm
Concrete Surface
Edge dropping
B,C,D edge : once
Face dropping
E,F,G face : once
Note 1 :No dew condensation to be observed.
Note 2 :The function test shall be conducted after 4 hours storage at the normal
Temperature and humidity after removed from the test chamber.
Note 3 :Vibration test will be conducted to the product itself without putting it in a container.
C-51505NFQJ-LR-AG (AG) No. 2002-0185
OPTREX CORPORATION
Page 11/18