SPS-33200W-CXX0G_2015 Datasheet, PDF (3/5 Pages) Optoway Technology Inc – 155 Mbps Digital Diagnostic LC SFP SINGLE-MODE TRANSCEIVER

Optoway
3
SPS-33200W-CXX0G
**********************************************************************************************************************************************************************
Electrical
Differential Output Voltage
V_OH – V_OL
0.6
2.0
V
Output LOS Voltage -- Low
V_OL
0
0.5
V
7
Output LOS Voltage -- High
V_OH
2.0
Vcc+0.3
V
7
6. Measured at 2²³-1 PRBS at BER 1E-10. Receiver sensitivity is better than -45dBm at 155 Mbps and 125 Mbps. However, due to the
resolution limitation of Digital Diagnostic Monitoring, the effect readout range for the RX received power at EEPROM A2 is from -10
to -34 dBm.
7. Open collector compatible, 4.7K to 10K ohm pull-up to Vcc (Host Supply Voltage).
CONNECTION DIAGRAM
PIN Signal Name
1 TX GND
2 TX Fault
3 TX Disable
4 MOD-DFE2
5 MOD-DEF1
6 MOD-DEF0
7 N/C
8 LOS
9 RX GND
10 RX GND
Description
PIN Signal Name
Description
Transmitter Ground
11 RX GND
Receiver Ground
Transmitter Fault Indication
12 RX DATA OUT- Inverse Receiver Data Out
Transmitter Disable (Module disables 13 RX DATA OUT+ Receiver Data Out
on high or open)
Modulation Definition 2 – Two wires 14 RX GND
Receiver Ground
serial ID Interface
Modulation Definition 1 – Two wires 15 Vcc RX
Receiver Power – 3.3V±5%
serial ID Interface
Modulation Definition 0 – Ground in 16 Vcc TX
Transmitter Power – 3.3V±5%
Module
Not Connected
17 TX GND
Transmitter Ground
Loss of Signal
18 TX DATA IN+ Transmitter Data In
Receiver Ground
19 TX DATA IN- Inverse Transmitter Data In
Receiver Ground
20 TX GND
Transmitter Ground
Module Definition
Module Definition
4
MOD-DEF2
PIN 4
SDA
MOD-DEF1
PIN 5
SCL
MOD-DEF0
PIN 6
LV-TTL Low
Interpretation by Host
Serial module definition
protocol
Module Definition 4 specifies a serial definition protocol. For this definition, upon power up, MOD-DEF(1:2) appear as no connector
(NC) and MOD-DEF(0) is TTL LOW. When the host system detects this condition, it activates the serial protocol. The protocol uses the
2-wire serial CMOS E²PROM protocol of the ATMEL AT24C01A/02/04 family of components.
***********************************************************************************************************************************************************************
OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303
Tel: [phone]
Fax: [phone]
E-mail: [e-mail] http: // www.optoway.com.tw 8/1/2008 V3.0