SPS-93160MG_15 Datasheet, PDF (2/5 Pages) Optoway Technology Inc – Multirate SFP LC SINGLE-MODE TRANSCEIVER

Optoway
2
SPS-93160MG
***********************************************************************************************************************************************************************
Transmitter Specifications (0^oC < Topr < 70^oC, 3.13V < Vcc < 3.47V)
Parameter
Symbol
Min
Typ
Max
Units
Notes
Optical
Optical Transmit Power
Output Center Wavelength
Output Spectrum Width
Side Mode Suppression Ratio
Extinction Ratio
Output Eye
Optical Rise Time
Optical Fall Time
Relative Intensity Noise
Po
5
---
8
dBm
1
λ
1520
1570
nm
∆λ
---
---
1
nm -20 dB Width
SMSR
30
dB
E_R
8.2
---
---
dB
Compliant with Telecordia GR-253-GORE and ITU-T Recommendation G.957
t_r
150
ps
20 % to 80% Values
t_f
150
ps
20 % to 80% Values
RIN
-120
dB/Hz
Dispersion Penalty
2.5
dB
2
Electrical
Data Input Current – Low
Data Input Current – High
I_IL
-350
I_IH
µA
350
µA
Differential Input Voltage
V_IH - V_IL
0.5
TX Disable Input Voltage – Low
T_{DIS, L}
0
TX Disable Input Voltage – High
T_{DIS, H}
2.0
TX Disable Assert Time
T_ASSERT
2.4
V
Peak-to-Peak
0.5
V
3
Vcc
V
2
10
µs
TX Disable Deassert Time
T_DEASSERT
1
ms
TX Fault Output Voltage -- Low
T_FaultL
0
0.5
V
4
TX Fault Output Voltage -- High
T_FaultH
2.0
Vcc+0.3
V
4
1. Output power is power coupled into a 9/125 µm single mode fiber.
2. Specified at 2700 ps/nm dispersion over G.652/G.654 fiber with center wavelength range of 1520 to 1570 nm.
3. There is an internal 4.7K to 10K ohm pull-up resistor to VccTX.
4. Open collector compatible, 4.7K to 10K ohm pull-up to Vcc (Host Supply Voltage).
Receiver Specifications (0^oC < Topr < 70^oC, 3.13V < Vcc < 3.47V)
Parameter
Symbol
Min
Typ
Max
Optical
Sensitivity @ OC-48
Sens1
-9
-30
Sensitivity @2X Fibre Channal
Sens2
-9
-30
Sensitivity @Gigabit Ethernet
Sens3
-9
-30
Sensitivity @OC-12
Sens4
-9
-30
Sensitivity @OC-3
Sens5
-18
-30
Signal Detect -- Asserted
Pa
---
-28
Signal Detect -- Deasserted
Pd
-40
---
---
Signal detect -- Hysteresis
1.0
---
Wavelength of Operation
1100
---
1600
Electrical
Differential Output Voltage
V_OH – V_OL
0.6
Output LOS Voltage -- Low
V_OL
0
Output LOS Voltage -- High
V_OH
2.0
5. Measured at 2²³-1 PRBS at BER 1E-10.
6. Measured at 2⁷-1 PRBS at BER 1E-12 .
2.0
0.5
Vcc+0.3
7. Open collector compatible, 4.7K to 10K ohm pull-up to Vcc (Host Supply Voltage).
Units
Notes
dBm
5
dBm
6
dBm
6
dBm
5
dBm
5
dBm Transition: low to high
dBm Transition: high to low
dB
nm
V
V
7
V
7
***********************************************************************************************************************************************************************
OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303
Tel: [phone]
Fax: [phone]
E-mail: [e-mail] http: // www.optoway.com.tw 1/1/2008 V1.0