English
Language : 

XPM-2101WG_10 Datasheet, PDF (1/9 Pages) Optoway Technology Inc – 10Gb/s 1310 nm XFP Extended Multi-Mode Optical Transceiver for 10GbE-LRM Applications
Optoway
1
XPM-2101WG
***********************************************************************************************************************************************************************
XPM-2101WG / XPM-2101BWG
(RoHS Compliant)
10Gb/s 1310 nm XFP Extended Multi-Mode Optical Transceiver for 10GbE-LRM Applications
**********************************************************************************************************************************************************************
FEATURES
DESCRIPTION
l Support 10.3125 Gbps
l Complaint with XFP MSA
l Compliant to IEEE 802.3aq-2006 10GBASE-LRM
l Link Length from 0.5 to 300 m with OM1 MMF
l Link Length from 0.5 to 300 m with OM2 MMF
l Link Length from 0.5 to 300 m with OM3 MMF
l 1310 nm Transmitter
l 2-Wire Interface for Integrated Digital Diagnostic
XPM-2101WG series extended multi-mode 10G XFP
transceiver is designed for serial optical data
communications such as 10 GBASE-LRM. It supports the
10Gbps transmission on both 50/125 µm and 62.5/125 µm
MMF.
The transceiver consists of two sections: The transmitter
section consists of a directly modulated 1310 nm FP laser,
driver and signal conditioner. The receiver section
Monitoring
l No reference clock required
l Low Power Dissipation < 2.0 W
l Only Required +3.3 V Power Supply
l RoHS Compliant
l 0 to 70oC Case Operating: XPM-2101WG
l -10 to 85oC Case Operating: XPM-2101BWG
l Duplex LC Connector
incorporates a PIN photodiode integrated with a
trans-impedance preamplifier (TIA) and signal conditioner.
The module is with the XFP 30-pin connector to allow
hot plug capability. Integrated Tx and Rx signal conditioners
provide high jitter-tolerance for full XFI compliance and no
external reference clock required. The internally ac coupled
high speed serial I/O simplifies interfacing to external
circuitry. Only single 3.3V power supply is needed. The
APPLICATIONS
optical output can be disabled by LVTTL logic high-level
input of TX_DIS. Loss of signal (RX_LOS) output is
l 10G Ethernet at 10.3125Gbps
provided to indicate the loss of an input optical signal of
receiver.
STANDARD
l Compliant with XFP MSA
l Compliant with IEEE 802.3aq-2006
A serial EEPROM in the transceiver allows the user to
access transceiver digital diagnostic monitoring and
configuration data via the 2-wire XFP Management
Interface. This interface uses a single address, A0h, with a
LASER SAFETY
This multi-mode transceiver is a Class 1 laser product. It
complies with IEC-60825 and FDA 21 CFR 1040.10 and
memory map divided into a lower and upper area. Basic
digital diagnostic data is held in the lower area while specific
data is held in a series of tables in the high memory area.
1040.11. The transceiver must be operated within the
specified temperature and voltage limits. The optical ports
of the module shall be terminated with an optical connector
or with a dust plug.
ORDER INFORMATION
P/No.
Bit Rate
(Gb/s)
Distance Wavelength
(m)
(nm)
Package
Connector
Temp
(oC)
RoHS
Compliant
XPM-2101WG
10.3125
300*
1310
XFP with DMI
LC
0 to 70
Yes
XPM-2101BWG
10.3125
300*
1310
XFP with DMI
LC
-10 to 85
Yes
*: see below table for transmission distance in MM fiber
Multimode Fiber Type**
ISO/IEC 11801:2002
Fiber Type
Operating Range
(m)
62.5 µm 160/500
62.5 µm 200/500
OM1
0.5 to 300
0.5 to 300
50 µm 500/500
OM2
0.5 to 300
50 µm 1500/500***
OM3
0.5 to 300
**: Each fiber type is identified by its core diameter followed by a pair of OFL bandwidth values separated by “/”. The OFL
bandwidths are in MHz-km and are for 850 nm and 1300nm respectively.
***: The OM3 fiber specification includes the 850 nm laser launch bandwidth in addition to the OFL bandwidth.
**********************************************************************************************************************************************************************
OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303
Tel: 886-3-5979798
Fax: 886-3-5979737
E-mail: sales@optoway.com.tw http: // www.optoway.com.tw 1/1/2010 V3.0