OSXX5630C1A150MA_VER.A.6 Datasheet, PDF (9/10 Pages) OptoSupply International – 5.6x3.0x0.8mm smd

5.6 x 3.0 x 0.8mm SMD
OSXX5630C1A-150mA
Ver.A.6
3) Manual soldering.
- Lead solder
℃ Max. 300 for max. 3sec, and only one time.
- Lead-free solder
℃ Max. 350 for max. 3sec, and only one time.
- There is possibility that the brightness of LEDs is decreased, which is influenced by heat or ambient
atmosphere during reflow. It is recommended to use the nitrogen reflow method use the nitrogen reflow
method.
- After LEDs have been soldered, repairs should not be done. As repair is unavoidable, a doublehead
soldering iron should be used. It should be confirmed beforehand whether the characteristics of the
LEDs will be damaged by repairing or not.
- Reflow soldering should not be done more than two times.
LED & Application Technologies