ODD-8SMD Datasheet, PDF (3/4 Pages) OptoDiode Corp – SURFACE MOUNT PHOTODIODE : High sensitivity, Short switching time

SURFACE MOUNT PHOTODIODE
1 _{Soldering Conditions}
ODD-900-002
1.0 Pb-free solder temperature profile
1~5°C/sec
1~5°C/sec
Pre-heating
180~200°C
260°C Max
10 sec Max
60 sec Max
Above 220°C
120 sec Max
1.1 Reflow soldering should not be done more than twice
1.2 Do not stress the PD while soldering
1.3 Don’t flex the circuit board after soldering
2.0 Soldering Iron
2.1 Each terminal should touch the tip of soldering iron (at 280°C) for less than for three seconds.
Use a minimum two second interval between soldering each terminal. Use caution as product
damage is often started during hand soldering.
2.2 The tip of soldering iron (at 280°) should be in contact with each terminal for less than
three seconds. Pause for a minimum two second interval between soldering each terminal.
Use caution as damage to the PD is often started during hand soldering.
Revision February 26, 2013
1260 Calle Suerte, Camarillo, California 93012
Phone: [phone], Fax: [phone]
Email: [e-mail], Website: www.optodiode.com