|
OLX-3000 Datasheet, PDF (1/2 Pages) – | |||
|
OptiLinx⢠OLX-3000
4.25 Gb/s 144-Port Optical Switch
High-Speed Optical Switching Between Ports
The OptiLinx⢠OLX-3000 is a versatile, multi-purpose,
non-blocking transparent optical switch that provides high-
speed switching between ports with minimal effect on overall
network latency. The OLX series is capable of switching digital
signals up to 4.25 Gb/s with any of its ports. Both a 4RU 144 -
port version and 8RU 288-port version are available. For smaller
applications, see the 16-port OLX-1000 series.
System Design
The OptiLinx⢠OLX-3000 is designed to accept up to three
modular port cards with up to forty-eight Small Form-Factor
Pluggable (SFP) transceiver modules per port card. Each SFP
transceiver module provides the physical ports for one input-
output pair. Different types of SFP transceivers support a variety
of network configurations:
⢠2.5, 2.125, 1.25 and 1.0625 Gb/s and 4.25 Gb/s link rates
available
⢠865, 1310 and 1550 Gb/s optical media (contact Opticomm
for CWDM & DWDM wavelengths)
⢠Links up to 80 km
The OptiLinx⢠OLX-3000 comes equipped with hot-swappable
power supplies, fans and port cards to allow users to quickly
replace parts without affecting system performance. The
OptiLinx⢠OLX-3000âs controlling software and non-volatile
configuration data resides on the module.
Features
⢠Remote monitoring and switching using Opticommâs
LinxView⢠software
⢠Up to 288-port versions available
⢠Full Duplex switching capacity up to 612 Gb/s
⢠Hot-pluggable SFP transceivers on all port cards
⢠Port cards, power supplies and fans are hot-swappable for
maximum flexibility
⢠Opticommâs LinxView⢠software allows the user to build
configurations by dragging and dropping ports
⢠Provides point-to-point, multiple loops, and multicast
topologies simultaneously
Remote Configuration and Easy Testing
OLX-3000 configuration commands are sent via a 10/100 Ethernet
connection using simple intuitive command sets. With regard to
network testing, some of the most significant capabilities are:
⢠Automatic and Remote Reconfiguration and Fault Emulation
Quickly establish links, emulate optical power breaks with and
without path failures, make topology changes, and re-route
point-to-point, loop or multicast connections.
⢠Dynamic Device Testing
Through out-of-band control the switch can simulate faults; also,
the capability exists to identify improperly operating devices.
⢠Increased Resource Sharing Capabilities
Switched connectivity between local or remote -- up to 50 km --
facilities and between devices allows testing without physically
moving equipment.
⢠Cable and Hardware Diagnostics
Quickly isolate interconnect problems; investigate whether the
network can provide reliable data transfer over specified
distances without touching cables; and test hardware
configurations such as hubs.
800-867-8426 ⢠info@opticomm.com ⢠www.opticomm.com ⢠Contact Opticomm for custom requirements.
Opticomm reserves the right to change specifications without notice
|
▷ |