OP130_14 Datasheet, PDF (3/4 Pages) OPTEK Technologies – Hermetic Infrared Emitting Diode

Hermetic Infrared Emitting Diode
OP130 Series
Absolute Maximum Ratings (T_A=25°C unless otherwise noted)
Storage Temperature Range
Operating Temperature Range
Reverse Voltage
Continuous Forward Current
Peak Forward Current (2 us pulse width, 0.1% duty cycle)
Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]
Power Dissipation
-65^o C to +150^o C
-65^o C to +125^o C
2.0 V
100 mA
10.0 A
260° C⁽¹⁾⁽²⁾
200 mW⁽³⁾
Electrical Characteristics (T_A = 25°C unless otherwise noted)
SYMBOL
PARAMETER
MIN TYP MAX UNITS
TEST CONDITIONS
Input Diode
Radiant Power Output
OP130, OP130W
P_O
OP131, OP131W
OP132, OP132W
OP133, OP133W
1.0 -
3.0 -
4.0 -
5.0 -
-
-
-
mW _{IF = 100 mA}^{(3 )}
-
V_F
Forward Voltage
-
- 1.75
V
I_F = 100 mA ⁽³⁾
I_R
Reverse Current
-
- 100 µA V_R= 2.0 V
λ_P
Wavelength at Peak Emission
- 935 -
nm I_F = 10 mA
β
Spectral Bandwidth between Half Power
Points
-
50
-
nm I_F = 10 mA
Notes:
1. RMA flux is recommended. Duration can be extended to 10 seconds maximum when flow soldering.
2. Derate linearly 2.0 mW/° C above 25° C.
3. Measurement made with 100 µs pulse measured at the trailing edge of the pulse with a duty cycle of 0.1% and an I_F = 100 mA.
Electrical Characteristics (T_A = 25°C unless otherwise noted — for reference only)
SYMBOL
PARAMETER
MIN TYP MAX UNITS
TEST CONDITIONS
Input Diode
∆λ_P /∆T
θ_HP
Spectral Shift with Temperature
Emission Angle at Half Power Points
OP130 series
OP130W series
- +0.30 - nm/°C I_F = Constant
-
-
18
50
-
-
I
Degree _F = 100 mA
t_r
Output Rise Time
t_f
Output Fall Time
- 1000 -
- 500 -
ns _{IF(PK)=100 mA, PW=10 µs, and}
ns ^D.C.=10.0%
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: [phone] or [phone]
FAX: [phone] [e-mail] www.optekinc.com
Issue B 10/2012
Page 3 of 4